HY5PS12421F-E3 Datasheet, PDF (11/35 Pages) Hynix Semiconductor – 512Mb DDR2 SDRAM

1HY5PS12421(L)F
HY5PS12821(L)F
HY5PS121621(L)F
3. AC & DC Operating Conditions
3.1 DC Operating Conditions
3.1.1 Recommended DC Operating Conditions (SSTL_1.8)
Symbol
Parameter
VDD
VDDL
VDDQ
VREF
VTT
Supply Voltage
Supply Voltage for DLL
Supply Voltage for Output
Input Reference Voltage
Termination Voltage
Min.
1.7
1.7
1.7
0.49*VDDQ
VREF-0.04
Rating
Typ.
1.8
1.8
1.8
0.50*VDDQ
VREF
Max.
1.9
1.9
1.9
0.51*VDDQ
VREF+0.04
Units
V
V
V
mV
V
Notes
4
4
1, 2
3
There is no specific device VDD supply voltage requirement for SSTL-1.8 compliance. However under all conditions VDDQ must
be less than or equal to VDD.
1. The value of VREF may be selected by the user to provide optimum noise margin in the system. Typically the value of VREF is
expected to be about 0.5 x VDDQ of the transmitting device and VREF is expected to track variations in VDDQ.
2. Peak to peak ac noise on VREF may not exceed +/-2% VREF (dc).
3. VTT of transmitting device must track VREF of receiving device.
4. VDDQ tracks with VDD, VDDL tracks with VDD. AC parameters are measured with VDD, VDDQ and VDDDL tied together
3.1.2 ODT DC electrical characteristics
PARAMETER/CONDITION
Rtt effective impedance value for EMRS(A6,A2)=0,1; 75 ohm
Rtt effective impedance value for EMRS(A6,A2)=1,0; 150 ohm
Rtt effective impedance value for EMRS(A6,A2)=1,1; 50 ohm
Deviation of VM with respect to VDDQ/2
Note 1: Test condition for Rtt measurements
SYMBOL MIN NOM MAX UNITS NOTES
Rtt1(eff) 60 75 90 ohm 1
Rtt2(eff) 120 150 180 ohm 1
Rtt2(eff) 40 50 60 ohm 1
delta VM -6
+6 % 1
Measurement Definition for Rtt(eff): Apply V_IH (ac) and V_IL (ac) to test pin separately, then measure current I(V_IH
(ac)) and I( V_IL (ac)) respectively. V_IH (ac), V_IL (ac), and VDDQ values defined in SSTL_18
V_IH (ac) - V_IL (ac)
Rtt(eff) =
I(V_IH (ac)) - I(V_IL (ac))
Measurement Definition for VM : Measurement Voltage at test pin(mid point) with no load.
delta VM =
2 x Vm
- 1 x 100%
VDDQ
Rev. 1.4 / July 2006
11