MC68HC908GR16A Datasheet, PDF (65/270 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

4.4 I/O Signals
The following paragraphs describe the CGM I/O signals.
I/O Signals
4.4.1 Crystal Amplifier Input Pin (OSC1)
The OSC1 pin is an input to the crystal oscillator amplifier.
4.4.2 Crystal Amplifier Output Pin (OSC2)
The OSC2 pin is the output of the crystal oscillator inverting amplifier.
4.4.3 External Filter Capacitor Pin (CGMXFC)
The CGMXFC pin is required by the loop filter to filter out phase corrections. An external filter network is
connected to this pin. (See Figure 4-2.)
NOTE
To prevent noise problems, the filter network should be placed as close to
the CGMXFC pin as possible, with minimum routing distances and no
routing of other signals across the network.
4.4.4 PLL Analog Power Pin (V_DDA)
V_DDA is a power pin used by the analog portions of the PLL. Connect the V_DDA pin to the same voltage
potential as the V_DD pin.
NOTE
Route V_DDA carefully for maximum noise immunity and place bypass
capacitors as close as possible to the package.
4.4.5 PLL Analog Ground Pin (V_SSA)
V_SSA is a ground pin used by the analog portions of the PLL. Connect the V_SSA pin to the same voltage
potential as the V_SS pin.
NOTE
Route V_SSA carefully for maximum noise immunity and place bypass
capacitors as close as possible to the package.
4.4.6 Oscillator Enable Signal (SIMOSCEN)
The SIMOSCEN signal comes from the system integration module (SIM) and enables the oscillator and
PLL.
4.4.7 Oscillator Enable in Stop Mode Bit (OSCENINSTOP)
OSCENINSTOP is a bit in the CONFIG2 register that enables the oscillator to continue operating during
stop mode. If this bit is set, the oscillator continues running during stop mode. If this bit is not set (default),
the oscillator is controlled by the SIMOSCEN signal which will disable the oscillator during stop mode.
4.4.8 Crystal Output Frequency Signal (CGMXCLK)
CGMXCLK is the crystal oscillator output signal. It runs at the full speed of the crystal (f_XCLK) and comes
directly from the crystal oscillator circuit. Figure 4-2 shows only the logical relation of CGMXCLK to OSC1
and OSC2 and may not represent the actual circuitry. The duty cycle of CGMXCLK is unknown and may
MC68HC908GR16A Data Sheet, Rev. 1.0
Freescale Semiconductor
65