MC68HC908AZ60A_13 Datasheet, PDF (355/414 Pages) Freescale Semiconductor, Inc – Microcontrollers

Table 27-2. BDLC Transceiver Delay (Continued)
BARD Offset Bits B0[3:0]
1000
1001
1010
1011
1100
1101
1110
1111
Corresponding Expected
Transceiver’s Delays (μs)
17
18
19
20
21
22
23
24
BDLC CPU Interface
27.6.2 BDLC Control Register 1
This register is used to configure and control the BDLC.
Address: $003C
Bit 7
6
5
4
3
2
1
Bit 0
Read:
0
0
IMSG
CLKS
R1
R0
IE
WCM
Write:
R
R
Reset: 1
1
1
0
0
0
0
0
R = Reserved
Figure 27-16. BDLC Control Register 1 (BCR1)
IMSG — Ignore Message Bit
This bit is used to disable the receiver until a new start-of-frame (SOF) is detected.
1 = Disable receiver. When set, all BDLC interrupt requests will be masked and the status bits will
be held in their reset state. If this bit is set while the BDLC is receiving a message, the rest of
the incoming message will be ignored.
0 = Enable receiver. This bit is cleared automatically by the reception of an SOF symbol or a BREAK
symbol. It will then generate interrupt requests and will allow changes of the status register to
occur. However, these interrupts may still be masked by the interrupt enable (IE) bit.
CLKS — Clock Bit
The nominal BDLC operating frequency (f_BDLC) must always be 1.048576 MHz or 1 MHz for J1850
bus communications to take place. The CLKS register bit allows the user to select the frequency
(1.048576 MHz or 1 MHz) used to adjust symbol timing automatically.
1 = Binary frequency (1.048576 MHz) selected for f_BDLC
0 = Integer frequency (1 MHz) selected for f_BDLC
R1 and R0 — Rate Select Bits
These bits determine the amount by which the frequency of the MCU CGMXCLK signal is divided to
form the MUX interface clock (f_BDLC) which defines the basic timing resolution of the MUX interface.
They may be written only once after reset, after which they become read-only bits.
The nominal frequency of f_BDLC must always be 1.048576 MHz or 1.0 MHz for J1850 bus
communications to take place. Hence, the value programmed into these bits is dependent on the
chosen MCU system clock frequency per Table 27-3
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
Freescale Semiconductor
355