|
FIN210AC Datasheet, PDF (9/17 Pages) Fairchild Semiconductor – 10-Bit Serializer / Deserializer Supporting Cameras and Small Displays up to 48MHz | |||
|
◁ |
Additional Application Information
Flex Cabling: The serial I/O information is transmitted at a high serial rate. Care must be taken implementing this serial I/O
flex cable. The following best practices should be used when developing the flex cabling or Flex PCB.
 Keep all four differential Serial Wires the same length.
 Do not allow noisy signals over or near differential serial wires.
Example: No LVCMOS traces over differential serial wires.
 Use only one ground plane or wire over the differential serial wires. Do not run ground over top and bottom.
 Design goal of 100Ω differential characteristic impedance.
 Do not place test points on differential serial wires.
 Use differential serial wires a minimum of 2cm away from the antenna.
 For additional applications notes or flex guidelines see your sales representative or contact Fairchild directly.
 For samples and questions, please contact: Interface@fairchildsemi.com.
© 2009 Fairchild Semiconductor Corporation
FIN210AC ⢠Rev. 1.0.1
9
www.fairchildsemi.com
|
▷ |