XRT73R12_07 Datasheet, PDF (76/89 Pages) Exar Corporation – TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT

XRT73R12
TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
REV. 1.0.2
TABLE 34: XRT73R12 REGISTER MAP SHOWING TRANSMIT CONTROL REGISTERS (TC_N)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
Reserved
Internal Insert PRBS
Transmit
Error
Drive Monitor
Reserved
TAOS
TxCLKINV
R/W
R/W
R/W
R/W
BIT 0
TxLEV
R/W
TABLE 35: TRANSMIT CONTROL REGISTER - CHANNEL N ADDRESS LOCATION = 0XM4
(N = [0:11] & M= 0-5 & 8-D)
BIT NUMBER
NAME
TYPE
DESCRIPTION
7-6
Reserved
5
Internal Transmit R/W Internal Transmit Drive Monitor Enable - Channel_n:
Drive Monitor
Enable
This READ/WRITE bit-field is used to configure the Transmit Section of
Channel_n to either internally or externally monitor the TTIP_n and
TRING_n output pins for bipolar pulses, in order to determine whether to
declare the Transmit DMO Alarm condition.
If the user configures the Transmit Section to externally monitor the TTIP_n
and TRING_n output pins (for bipolar pulses) then the user must connect
the MTIP_n and MRING_n input pins to their corresponding TTIP_n and
TRING_n output pins (via a 270 ohm series resistor).
If the user configures the Transmit Section to internally monitor the TTIP_n
and TRING_n output pins (for bipolar pulses), the user does NOT need to
conect the MTIP_n and MRING_n input pins. This monitoring will be per-
formed internally at the TTIP_n and TRING_n pads.
0 - Configures the Transmit Drive Monitor to externally monitor the TTIP_n
and TRING_n output pins for bipolar pulses.
1 - Configures the Transmit Drive Monitor to internally monitor the TTIP_n
and TRING_n output pins for bipolar pulses.
4
Insert PRBS Error R/W Insert PRBS Error - Channel_n:
A "0 to 1" transition within this bit-field causes the PRBS Generator (within
the Transmit Section of Channel_n) to generate a single bit error within the
outbound PRBS pattern-stream.
NOTES:
1. This bit-field is only active if the PRBS Generator and Receiver
have been enabled within the corresponding Channel.
2. After writing the "1" into this register, the user must execute a write
operation to clear this particular register bit to "0" in order to
facilitate the next "0 to 1" transition in this bit-field.
3
Reserved
73