XRT73R12_07 Datasheet, PDF (61/89 Pages) Exar Corporation – TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT

XRT73R12
REV. 1.0.2
TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
THE GLOBAL/CHIP-LEVEL REGISTERS
The register set, within the XRT73R12 contains ten global or chip-level registers. These registers control
operations in more than one channel or apply to the complete chip. This section will present detailed
information on the Global Registers.
ADDRESS
0x00
0x08
0x80
0x88
0x60
0x61
0xE0
0xE1
0x6E
0x6F
TABLE 18: LIST AND ADDRESS LOCATIONS OF GLOBAL REGISTERS
COMMAND
REGISTER
CR0
LABEL
APST
TYPE
REGISTER NAME
R/W APS Transmit Redundancy Control Register 0-5
CR8
APSR R/W APS Receive Redundancy Control Register 0-5
CR128
CR136
APST
APSR
R/W APS Transmit Redundancy Control Register 6-11
R/W APS Receive Redundancy Control Register 6-11
CR96
CIE
R/W Channel 0-5 Interrupt Enable flags
CR97
CIS
R/O Channel 0-5 Interrupt Status flags
CR224
CR225
CIE
R/W Channel 6-11 Interrupt Enable flags
CIS
R/O Channel 6-11 Interrupt Status flags
CR110
PN
ROM Device Part Number Register
CR111
VN
ROM Chip Revision/Version Number Register
REGISTER DESCRIPTION - GLOBAL REGISTERS
TABLE 19: APS/REDUNDANCY TRANSMIT CONTROL REGISTER - CR0 (ADDRESS LOCATION = 0X00)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Reserved Reserved TxON Ch 5 TxON Ch 4 TxON Ch 3 TxON Ch 2 TxON Ch 1 TxON Ch 0
R/W
R/W
R/W
R/W
R/W
R/W
BIT
NUMBER
NAME
7,6
Reserved
5
TxON Ch 5
4
TxON Ch 4
3
TxON Ch 3
2
TxON Ch 2
1
TxON Ch 1
0
TxON Ch 0
TYPE
DESCRIPTION
R/W Transmit Section ON - Channel n
This READ/WRITE bit-field is used to turn on or turn off the Transmit Driver associated
with Channel n. If the user turns on the Transmit Driver, then Channel n will transmit
DS3, E3 or STS-1 pulses on the line via the TTIP_n and TRING_ n output pins.
Conversely, if the user turns off the Transmit Driver, then the TTIP_n and TRING_n
output pins will be tri-stated.
0 - Shuts off the Transmit Driver associated with Channel n and tri-states the TTIP_n
and TRING_ n output pins.
1 - Turns on the Transmit Driver associated with Channel n.
NOTE: The master TxON control pin(pin # P4) must be in a high state (logic 1) for this
operation to turn on any channel.
58