XR16L2750_05 Datasheet, PDF (32/48 Pages) Exar Corporation – 2.25V TO 5.5V DUART WITH 64-BYTE FIFO

XR16L2750
2.25V TO 5.5V DUART WITH 64-BYTE FIFO
EMSR[5:4]: Extended RTS Hysteresis
TABLE 13: AUTO RTS HYSTERESIS
EMSR
BIT-5
EMSR
BIT-4
FCTR
BIT-1
FCTR
BIT-0
RTS#
HYSTERESIS
(CHARACTERS)
0
0
0
0
0
0
0
0
1
±4
0
0
1
0
±6
0
0
1
1
±8
0
1
0
0
±8
0
1
0
1
±16
0
1
1
0
±24
0
1
1
1
±32
1
0
0
0
±40
1
0
0
1
±44
1
0
1
0
±48
1
0
1
1
±52
1
1
0
0
±12
1
1
0
1
±20
1
1
1
0
±28
1
1
1
1
±36
xr
REV. 1.2.1
EMSR[6]: LSR Interrupt Mode
• Logic 0 = LSR Interrupt Delayed (for 16C2550 compatibility, default). LSR bits 2, 3, and 4 will generate an
interrupt when the character with the error is in the RHR.
• Logic 1 = LSR Interrupt Immediate. LSR bits 2, 3, and 4 will generate an interrupt as soon as the character is
received into the FIFO.
EMSR[7]: 16X Sampling Rate Mode
Logic 0 = 8X Sampling Rate.
Logic 1 = 16X Sampling Rate (for 16C550 compatibility, default).
4.12 FIFO Level Register (FLVL) - Read-Only
The FIFO Level Register replaces the Scratchpad Register (during a Read) when FCTR[6] = 1. Note that this is
not identical to the FIFO Data Count Register which can be accessed when LCR = 0xBF.
FLVL[7:0]: FIFO Level Register
This register provides the FIFO counter level for the RX FIFO or the TX FIFO or both depending on EMSR[1:0].
See Table 12 for details.
4.13 Baud Rate Generator Registers (DLL and DLM) - Read/Write
The concatenation of the contents of DLM and DLL gives the 16-bit divisor value which is used to calculate the
baud rate:
• Baud Rate = (Clock Frequency / 16) / Divisor
See MCR bit-7 and the baud rate table also.
4.14 Device Identification Register (DVID) - Read Only
This register contains the device ID (0x0A for XR16L2750). Prior to reading this register, DLL and DLM should
be set to 0x00.
32