XR16L788IQ-F Datasheet, PDF (31/54 Pages) Exar Corporation – HIGH PERFORMANCE 2.97V TO 5.5V OCTAL UART

XR16L788
REV. 1.2.3
HIGH PERFORMANCE 2.97V TO 5.5V OCTAL UART
4.4.1 Interrupt Generation:
• LSR is by any of the LSR bits 1, 2, 3 and 4.
• RXRDY is by RX trigger level.
• RXRDY Time-out is by a 4-char plus 12 bits delay timer.
• TXRDY is by TX trigger level or TX FIFO empty (or transmitter empty in auto RS-485 control).
• MSR is by any of the MSR bits 0, 1, 2 and 3.
• Receive Xon/Xoff/Special character is by detection of a Xon, Xoff or Special character.
• CTS#/DSR# is when its transmitter toggles the input pin (from LOW to HIGH) during auto CTS/DSR flow
control enabled by EFR bit-7 and selection on MCR bit-2.
• RTS#/DTR# is when its receiver toggles the output pin (from LOW to HIGH) during auto RTS/DTR flow
control enabled by EFR bit-6 and selection on MCR bit-2.
4.4.2 Interrupt Clearing:
• LSR interrupt is cleared by a read to the LSR register.
• RXRDY interrupt is cleared by reading data until FIFO falls below the trigger level.
• RXRDY Time-out interrupt is cleared by reading RHR.
• TXRDY interrupt is cleared by a read to the ISR register or writing to THR.
• MSR interrupt is cleared by a read to the MSR register.
• Xon or Xoff interrupt is cleared by a read to ISR register.
• Special character interrupt is cleared by a read to ISR or after the next character is received.
• RTS#/DTR# and CTS#/DSR# status change interrupts are cleared by a read to the MSR register.
]
TABLE 13: INTERRUPT SOURCE AND PRIORITY LEVEL
PRIORITY
ISR REGISTER STATUS BITS
SOURCE OF THE INTERRUPT+
LEVEL BIT-5 BIT-4 BIT-3 BIT-2 BIT-1
BIT-0
1
0
0
0
1
1
0 LSR (Receiver Line Status Register)
2
0
0
0
1
0
0 RXRDY (Received Data Ready)
3
0
0
1
1
0
0 RXRDY (Receive Data Time-out)
4
0
0
0
0
1
0 TXRDY (Transmitter Holding Register Empty)
5
0
0
0
0
0
0 MSR (Modem Status Register)
6
0
1
0
0
0
0 RXRDY (Received Xon/Xoff or Special character)
7
1
0
0
0
0
0 CTS#/DSR#, RTS#/DTR# change of state
X
0
0
0
0
0
1 None (default)
ISR[0]: Interrupt Status
• Logic 0 = An interrupt is pending and the ISR contents may be used as a pointer to the appropriate interrupt
service routine.
• Logic 1 = No interrupt pending. (default condition)
ISR[5:1]: Interrupt Status
These bits indicate the source for a pending interrupt at interrupt priority levels (See Table 13). See “Section
4.4.1, Interrupt Generation:” on page 31 and “Section 4.4.2, Interrupt Clearing:” on page 31 for details.
31