XRT79L73 Datasheet, PDF (29/71 Pages) Exar Corporation – 3 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC

ÿþ
PRELIMINARY
3 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC
XRT79L73
REV. P1.0.0
PIN #
J2
E25
K3
E2
D22
G4
F1
E22
H1
E3
E21
G5
NAME
RxLOS1
RxLOS2
RxLOS3
RxPRED1
RxPRED2
RxPRED3
RxPOOF1
RxPOOF2
RxPOOF3
RxPLOF1
RxPLOF2
RxPLOF3
TYPE
O
O
O
OO
O
O
O
O
O
O
O
O
DESCRIPTION
Framer/UNI - Loss of Signal Output Indicator:
These pins are asserted when the Receive Section of the XRT79L73 encoun-
ters 180 consecutive 0's (for DS3 applications) or 32 consecutive 0's (for E3
applications) via the RxPOS and RxNEG pins. These pins will be negated once
the Receive DS3/E3 Framer has detected at least 60 "1s" out of 180 consecu-
tive bits (for DS3 applications) or has detected at least four consecutive 32 bit
strings of data that contain at least 8 "1s" in the receive path.
Receiver Red Alarm Indicator - Receive PLCP Processor:
• The XRT79L73 device will assert this output pin (e.g., toggle it "high")
anytime (and for the duration that) the Receive PLCP Processor block is
currently declaring any of the following defect conditions. PLCP OOF - Out of
Frame Defect Condition
• PLCP LOF - Loss of Frame Defect Condition
Conversely, the XRT79L73 device will negate this output pin (e.g.,
toggle it "low") anytime (and for the duration that) the Receive PLCP
Processor block is NOT declaring any of the above-mentioned defect
conditions.
NOTE: These output pins are only valid if the XRT79L73 has been configured to
operate in the ATM/PLCP Mode.
Receive PLCP Processor Block - PLCP Out of Frame Defect Indicator:
The XRT79L73 device will assert this output pin (e.g., toggle it "high") anytime
(and for the duration that) the Receive PLCP Processor block is currently
declaring the PLCP OOF (Out of Frame) defect condition.
Conversely, the XRT79L73 device will negate this output pin (e.g., toggle it
"low") anytime (and for the duration that) the Receive PLCP Processor block is
NOT declaring the PLCP OOF defect condition.
NOTE: These output pins are only active if the XRT79L73 has been configured
to operate in both the UNI and PLCP Mode.
Receive PLCP Processor Block - PLCP Loss of Frame Defect Indicator
Output
The XRT79L73 device will assert this output pin (e.g., toggle it "high")
anytime (and for the duration that) the Receive PLCP Processor block
is currently declaring the PLCP LOF (Loss of Frame) defect
condition.Conversely, the XRT79L73 device will negate this output pin
(e.g., toggle it "low") anytime (and for the duration that) the Receive
PLCP Processor block is NOT declaring the PLCP LOF defect
condition.
NOTE: These output pins are only active is the XRT79L73 has been configured
to operate in the ATM/PLCP Mode.
27