ISE40-T1-22 Datasheet, PDF (6/17 Pages) List of Unclassifed Manufacturers – High Precision, Digital Pressure Switch

Series ZSE40/ISE40
Calibration Procedures
Initial Setting
1. Initial condition mode 2. Selection of output mode OUT1
3. Selection of output mode OUT2
SET
Press the “SET” button.
Press the “SET” button for more
than 2 seconds until “ ” is
displayed.
Release it when the display turns
to “ ”.
Unit mode: When using a product with
a unit switching function,
refer to the next page for
unit-setting (for overseas).
Select the “output mode” for
OUT1 by pressing either į but-
ton or Ĭ button.
“ ” Normally open mode
“ ” Normally closed mode
4. Selection of response time
Select the “output mode” for
OUT2 by pressing either į
button or Ĭ button.
“ ” Normally open mode
“ ” Normally closed mode
5. Setting Auto/Manual
SET
Press the “SET” button.
SET
Press the “SET” button.
SET
Press the “SET” button
to complete the setting.
Manual Pressure Setting
Output mode differs by the pressure set value.
Select the response time by
pressing either į button or Ĭ
button.
(“ ”: 2.5 ms, “ ”: 24 ms,
“ ”: 192 ms,“ ”: 768 ms
Select among them.)
Select “Auto preset mode” or
“Manual set mode” by pressing
either į button or Ĭ button.
“ ” Auto preset mode
“ ” Manual set mode
1. Manual set mode
2. Input set point value for OUT1 (1)
3. Input set point value for OUT1 (2)
Select the manual set mode in
the initial condition mode and
press the “SET” button until
“ ” or “ ” is displayed.
SET
Press the “SET” button.
į button: Increases set value
Ĭ button: Decreases set value
Displays the set values “ ” or
“ ” alternately.
į button: Increases set value
Ĭ button: Decreases set value
Displays the set values “ ” or
“ ” alternately.
4. Input set point value for OUT2 (1)
5. Input set point value for OUT2 (2)
6. Display of setting auto shift
SET
Press the “SET” button.
SET
Press the “SET” button.
SET
Press the “SET” button.
SET
Press the “SET” button
to complete the setting.
į button: Increases set value
Ĭ button: Decreases set value
Displays the set values “ ” or
“ ” alternately.
į button: Increases set value
Ĭ button: Decreases set value
Displays the set values “ ” or
“ ” alternately.
∗ Only for ZSE40(F)/ISE40-„-30/70(L)-M,
displays the input mode “ ” and the
compensation value alternately.
If auto shift input is not complete, zero
is displayed.
16-2-20