NT5SV64M4AT Datasheet, PDF (32/65 Pages) List of Unclassifed Manufacturers – 256Mb Synchronous DRAM

NT5SV64M4AT(L)
NT5SV32M8AT(L)
NT5SV16M16AT(L)
256Mb Synchronous DRAM
Current State Truth Table (Part 2 of 3)(See note 1)
Command
Current State
CS RAS CAS WE BA0,BA1 A12 - A0
Description
Action
LLLL
OP Code
Mode Register Set ILLEGAL
LLLH
X
X
Auto or Self Refresh ILLEGAL
Read with
Auto Pre-
charge
L LHL
L LHH
LHL L
LHL H
BS
X
Precharge
BS Row Address Bank Activate
BS
Column Write
BS
Column Read
ILLEGAL
ILLEGAL
ILLEGAL
ILLEGAL
LHHH
X
X
No Operation
Continue the Burst
HX XX
X
X
Device Deselect
Continue the Burst
LLLL
OP Code
Mode Register Set ILLEGAL
LLLH
X
X
Auto or Self Refresh ILLEGAL
L LHL
BS
X
Precharge
ILLEGAL
Write with Auto ^{L L H H}
Precharge
LHL L
BS Row Address Bank Activate
BS
Column Write
ILLEGAL
ILLEGAL
LHL H
BS
Column Read
ILLEGAL
LHHH
X
X
No Operation
Continue the Burst
HX XX
X
X
Device Deselect
Continue the Burst
LLLL
OP Code
Mode Register Set ILLEGAL
LLLH
X
X
Auto or Self Refresh ILLEGAL
L LHL
L LHH
Precharging
LHL L
BS
X
Precharge
BS Row Address Bank Activate
BS
Column Write
No Operation; Bank(s) idle after t_RP
ILLEGAL
ILLEGAL
LHL H
BS
Column Read
ILLEGAL
LHHH
HX XX
LLLL
X
X
X
X
OP Code
No Operation
Device Deselect
Mode Register Set
No Operation; Bank(s) idle after t_RP
No Operation; Bank(s) idle after t_RP
ILLEGAL
LLLH
X
X
Auto or Self Refresh ILLEGAL
L LHL
BS
X
Precharge
ILLEGAL
Row
Activating
L LHH
LHL L
BS Row Address Bank Activate
BS
Column Write
ILLEGAL
ILLEGAL
LHL H
BS
Column Read
ILLEGAL
LHHH
X
HX XX
X
X
No Operation
No Operation; Row Active after t_RCD
X
Device Deselect
No Operation; Row Active after t_RCD
Notes
4
4
4
4
4
4
4
4
4
4
4
4
4, 10
4
4
1. CKE is assumed to be active (high) in the previous cycle for all entries. The Current State is the state of the bank that the Command is
being applied to.
2. All Banks must be idle; otherwise, it is an illegal action.
3. If CKE is active (high) the SDRAM will start the Auto (CBR) Refresh operation, if CKE is inactive (low) than the Self Refresh mode is
entered.
4. The Current State refers to only one of the banks. If BS selects this bank then the action is illegal. If BS selects the bank no t being refer-
enced by the Current State then the action may be legal depending on the state of that bank.
5. If CKE is inactive (low) then the Power Down mode is entered; otherwise there is a No Operation.
6. The minimum and maximum Active time (t_RAS) must be satisfied.
7. The RAS to CAS Delay (t _RCD) must occur before the command is given.
8. Column address A10 is used to determine if the Auto Precharge function is activated.
9. The command must satisfy any bus contention, bus turn around, and/or write recovery requirements.
10. The command is illegal if the minimum bank to bank delay time (t _RRD ) is not satisfied.
REV 1.0
May, 2001
32
© NANYA TECHNOLOGY CORP. All rights reserved.
NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.