SD1010A Datasheet, PDF (36/45 Pages) List of Unclassifed Manufacturers – Analog-Interface XGA TFT LCD Display Controller

SmartASIC, Inc.
SD1010A
Interpolation H.
8
Offset
Interpolation H.
8
Offset
Interpolation V.
8
Offset
Interpolation V.
8
Offset
H. Interpolation Rest 8
Count
H. Interpolation
8
Reset Count
V. Interpolation
8
Reset Count
V. Interpolation
8
Reset Count
OSD R Weight
8
OSD G Weight
8
OSD B Weight
8
Advanced Processing 8
R Weight
Advanced Processing 8
G Weight
Advanced Processing 8
B Weight
Advanced Processing 8
R Value
Advanced Processing 8
G Value
Advanced Processing 8
B Value
Brightness
8
Adjustment
Pixel Comparison
8
Value
Status 2
8
*This is a option for Advanced Post Processing
Bit [7:5]: Reserved
RW 30H[7:0] High Byte For Interpolation Horizontal Offset
Default is 00H
RW 31H[7:0] Low Byte For Interpolation Horizontal Offset
Default is 00H
RW 32H{7:0] High Byte For Interpolation Vertical Offset
Default is 00H
RW 33H[7:0] Low Byte For Interpolation Vertical Offset
Default is 00H
RW 34H[7:0] Bit [2:0]: High Bits For Horizontal Interpolation Reset
Count. Default is 0H.
Bit [7:3]: Reserved
RW 35H[7:0] Low Byte For Horizontal Interpolation Reset Count.
Default is 00H.
RW 36H[7:0] Bit [1:0]: High Bits For Vertical Interpolation Reset
Count. Default is 0H.
RW 37H[7:0] Low Byte For Interpolation Vertical Reset Count.
Default is 00H.
RW 38H[7:0] Mixing Weight For OSD R. Default is 00H.
RW 39H[7:0] Mixing Weight For OSD G. Default is 00H.
RW 3AH[7:0] Mixing Weight For OSD B. Default is 00H.
RW 3BH[7:0] Weight For Advanced Post Processing R
default is 00H
RW 3CH[7:0] Weight For Advanced Post Processing G
Default is 00H
RW 3DH[7:0] Weight For Advanced Post Processing B
Default is 00H
RW 3EH[7:0] Value For Advanced Post Processing R
Default is 00H
RW 3FH[7:0] Value For Advanced Post Processing G
Default is 00H
RW 40H[7:0] Value For Advanced Post Processing B
Default is 00H
RW 41H[7:0] The Adjust Amount For Reducing/Increasing
Brightness. Default is 00H.
RW 42H[7:0] The Value To Compare The Incoming Pixel Data.
Default is 00H.
R 43H[7:0] The Status Register 2
Bit [1:0]: Result for comparing the selected incoming
pixel with “Pixel Comparison Value”:
0: invalid
1: incoming pixel > “Pixel Comparison Value”
2: incoming pixel = “Pixel Comparison Value”
3: incoming pixel < “Pixel Comparison Value”
Bit [2]: Status for brightness control
0: Normal, no underflow/overflow
1: brightness reduced too much causes
underflow/increased too much causes overflow
November, 1999
SmartASIC Confidential
36
Revision B