E909-05 Datasheet, PDF (20/67 Pages) ELMOS Semiconductor AG – The HALIOS® multi purpose optical sensor is based on an optical bridge which provides a contactless detec-tion of gestures (e.g. movement of a finger).

HALIOS® MULTI-PURPOSE OPTICAL SENSOR WITH HIGH LIGHT IMMUNITY
E909.05
PRELIMINARY INFORMATION AUG 02, 2011
Register Measurement Configuration (0x02)
MSB
LSB
Content
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reset value
0 00 0 0 0 0 0 0 0 0 0 0 0 0 0
Internal access R/W R/ R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
W
External access R/W R/ R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
W
Bit Description
15 : HALMEAS: Starts a new measurement phase, switching from '0' to '1' starts measure-
ment. After measurement the bit resets itself.
14 : ACCON: En/disables the acceleration of the integrator
('0' = disabled, '1' = enabled)
13 : Deactivation of AN input to reduce current consumption in the case that only the CA
input is used
('0' = active, '1' = deactivated)
12 : AON: Control of analogue part
('0' = off, '1' = on)
11 : FIXB: Sets the LEDs activated in phase B to fixed sending current
('0' = variable, '1' = fixed)
10 : FIXA: Sets the LEDs activated in phase A to fixed sending current
('0' = variable, '1' = fixed)
9 : LED C A: Decides if LED is active for the measurement
('0' = off, '1' = on)
Note: Bits 9 down to 0 will be reset after measurement
8 : LED C B: Decides if LED is active for the measurement
('0' = off, '1' = on)
7 : LED 4 A: Decides if LED is active for the measurement
('0' = off, '1' = on)
Note: not available in version 1 and version 2
6 : LED 4 B: Decides if LED is active for the measurement
('0' = off, '1' = on)
Note: not available in version 1 and version 2
5 : LED 3 A: Decides if LED is active for the measurement
('0' = off, '1' = on)
Note: not available in version 1 and version 2
4 : LED 3 B: Decides if LED is active for the measurement
('0' = off, '1' = on)
Note: not available in version 1 and version 2
3 : LED 2 A: Decides if LED is active for the measurement
('0' = off, '1' = on)
2 : LED 2 B: Decides if LED is active for the measurement
('0' = off, '1' = on)
1 : LED 1 A: Decides if LED is active for the measurement
('0' = off, '1' = on)
0 : LED 1 B: Decides if LED is active for the measurement
('0' = off, '1' = on)
Table 5.6.3.3: Measurement Configuration
This document contains information on a pre-production product. ELMOS Semiconductor AG reserves the right to change specifications and information herein without notice.
ELMOS Semiconductor AG
Data Sheet 20 / 67
QM-No.: 25DS0014E.00