STC3800_15 Datasheet, PDF (7/48 Pages) Connor-Winfield Corporation – INTEGRATED - STRATUM 3E TIMING SOURCE

Register Map continued
Table 4
Address Reg Name
0x06
0x07
0x08
0x09
Max_Pullin_Range
Xref_Activity
Ref_Activity
Ref_Pullin_Sts
0x0a
0x0b
0x0c
0x0d
0x0e
Ref_Qualified
Ref_Mask
Ref_Available
Ref_Rev_Delay
MS_Phase_Offset
0x0f
0x10
0x11
0x12
0x13
0x14
0x15
0x16
0x17
0x18
0x19
0x1a
0x1b
0x1c
0x1d
0x1e
0x1f
0x20
0x21
0x22
0x23
0x24
0x25
0x26
0x27
0x30
0x31
0x32
0x33
0x36
0x37
0x38
0x39
Calibration
Fr_Pulse_Width
DPLL_Status
Intr_Event
Intr_Enable
Ref1_Frq_Offset
Ref2_Frq_Offset
Ref3_Frq_Offset
Ref4_Frq_Offset
Ref5_Frq_Offset
Ref6_Frq_Offset
Ref7_Frq_Offset
Ref8_Frq_Offset
Ref1_Frq_Priority
Ref2_Frq_Priority
Ref3_Frq_Priority
Ref4_Frq_Priority
Ref5_Frq_Priority
Ref6_Frq_Priority
Ref7_Frq_Priority
Ref8_Frq_Priority
Free Run_Priority
History_Policy
History_Cmd
Hold Over_Time
Cfgdata
Cfgctr_Lo
Cfgctr_Hi
Chksum
EE_Wrt_Mode
EE_Cmd
EE_Page_Num
EE_FIFO_Port
Description
Type
Maximum pull-in range in 0.1 ppm units
R/W
Cross Reference activity and frequency
R
Activities of 8 reference inputs
R
In or out of pull-in range of 8 reference inputs
R
Qualification of 8 reference inputs
R
Availability mask for 8 reference inputs
R/W
Availability of 8 reference inputs
R
Reference reversion delay time, 0 - 255 minutes
R/W
Phase offset between Xref & Sync_8K
(for the slave in M/S Operation), in 250 pS resolution
R/W
Digital Free Run clock calibration in 0.05 ppm resolution
R/W
Frame and multi-frame sync pulse width
R/W
Digital Phase Locked Loop status
R
Interrupt events
R
Enable individual interrupt events
R/W
Ref1 frequency offset in 0.2 ppm resolution
R
Ref2 frequency offset in 0.2 ppm resolution
R
Ref3 frequency offset in 0.2 ppm resolution
R
Ref4 frequency offset in 0.2 ppm resolution
R
Ref5 frequency offset in 0.2 ppm resolution
R
Ref6 frequency offset in 0.2 ppm resolution
R
Ref7 frequency offset in 0.2 ppm resolution
R
Ref8 frequency offset in 0.2 ppm resolution
R
Ref1 frequency and priority
R/W
Ref2 frequency and priority
R/W
Ref3 frequency and priority
R/W
Ref4 frequency and priority
R/W
Ref5 frequency and priority
R/W
Ref6 frequency and priority
R/W
Ref7 frequency and priority
R/W
Ref8 frequency and priority
R/W
Control and priority for designation of Free Run as a reference
R/W
Sets policy for Hold Over history accumulation
R/W
Save, restore, and flush commands for Hold Over History
R/W
Indicates the time since entering the Hold Over state
R
Configuration data write register
R/W
Configuration data write counter, low byte
R
Configuration data write counter, high byte
R
Configuration data checksum pass/fail indicator
R
Disables/Enables writing to the external EEPROM
R/W
Read/Write command and ready indication register for external EEPROM Access R/W
Page number for external EEPROM access
R/W
Read/Write data for external EEPROM access
R/W
Preliminary Data Sheet #: TM061 Page 7 of 48 Rev: P06 Date: 11/22/04
© Copyright 2001 The Connor-Winfield Corp. All Rights Reserved Specifications subject to change without notice