|
CDB5376 Datasheet, PDF (9/78 Pages) Cirrus Logic – Multichannel Seismic Evaluation System | |||
|
◁ |
CDB5376
1.3 Software Setup
1.3.1 PC Requirements
The PC hardware requirements for the Cirrus Seismic Evaluation system are:
⢠Windows XPâ¢, Windows 2000â¢, Windows NT®
⢠Intel® Pentium® 600MHz or higher microprocessor
⢠VGA resolution or higher video card
⢠Minimum 64MB RAM
⢠Minimum 40MB free hard drive space
1.3.2 Seismic Evaluation Software Installation
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
To install the Cirrus Logic Seismic Evaluation Software:
⢠Go to the Cirrus Logic Industrial Software web page (http://www.cirrus.com/industrialsoftware). Click
the link for âCirrus Seismic Evaluation GUIâ to get to the download page and then click the link for âCir-
rus Seismic Evaluation GUI Release Vxxâ (xx indicates the version number).
⢠Read the software license terms and click âAcceptâ to download the âSeismicEvalGUI_vxx.zipâ file to
any directory on the PC.
⢠Unzip the downloaded file to any directory and a âdistributionâ sub-folder containing the installation ap-
plication will automatically be created.
⢠Open the âdistributionâ sub-folder and run âsetup.exeâ. If the Seismic Evaluation Software has been
previously installed, the uninstall wizard will automatically remove the previous version and you will
need to run âsetup.exeâ again.
⢠Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard. The default in-
stallation location is âC:\Program Files\Cirrus Seismic Evaluationâ.
An application note, AN271 - Cirrus Seismic Evaluation GUI Installation Guide, is available from the Cirrus
Logic web site with step-by-step instructions on installing the Seismic Evaluation Software.
1.3.3 USBXpress Driver Installation
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
The Cirrus Logic Seismic Evaluation Software communicates with CDB5376 via USB using the USBX-
press driver from Silicon Laboratories (http://www.silabs.com). For convenience, the USBXpress driver
files are included as part of the installation package.
To install the USBXpress driver (after installing the Seismic Evaluation Software):
DS612DB2
9
|
▷ |