|
CDB5376 Datasheet, PDF (10/78 Pages) Cirrus Logic – Multichannel Seismic Evaluation System | |||
|
◁ |
CDB5376
⢠Connect CDB5376 to the PC through an available USB port and apply power. The PC will detect
CDB5376 as an unknown USB device.
⢠If prompted for a USB driver, skip to the next step. If not, using Windows Hardware Device Manager
go to the properties of the unknown USB API device and select âUpdate Driverâ.
⢠Select âInstall from a list or specific locationâ, then select âInclude this location in the searchâ and then
browse to âC:\Program Files\Cirrus Seismic Evaluation\Driver\â. The PC will recognize and install the
USBXpress device driver.
⢠After driver installation, cycle power to CDB5376. The PC will automatically detect it and add it as a
USBXpress device in the Windows Hardware Device Manager.
An application note, AN271 - Cirrus Seismic Evaluation GUI Installation Guide, is available from the Cirrus
Logic web site with step-by-step instructions on installing the USBXpress driver.
1.3.4 Launching the Seismic Evaluation Software
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
To launch the Cirrus Seismic Evaluation Software, go to:
⢠Start à Programs à Cirrus Seismic Evaluation à Cirrus Seismic Evaluation
or:
⢠C:\Program Files\Cirrus Seismic Evaluation\SeismicGUI.exe
For the most up-to-date information about the software, please refer to its help file:
⢠Within the software: Help à Contents
or:
⢠Start à Programs à Cirrus Seismic Evaluation à SEISMICGUI
or:
⢠C:\Program Files\Cirrus Seismic Evaluation\SEISMICGUI.HLP
10
DS612DB2
|
▷ |