CS4354 Datasheet, PDF (14/25 Pages) Cirrus Logic – 5 V Stereo DAC with 2 VRMS Ground-centered Output

CS4354
4.4 Serial Clock
The serial clock controls the shifting of data into the input data buffers. The CS4354 supports both external
and internal serial clock generation modes. Refer to Figure 6 for a diagram of the I²S data format.
LRCK
Left Channel
Right Channel
SCLK
SDIN
MSB -1 -2 -3 -4 -5
+5 +4 +3 +2 +1 LSB
MSB -1 -2 -3 -4
+5 +4 +3 +2 +1 LSB
Figure 6. CS4354 Data Format (I²S)
In order to support selectable de-emphasis without a dedicated pin, pin 5 (SCLK/DEM) functions both as
a serial clock input and a de-emphasis select. In typical applications where de-emphasis is not required,
the SCLK/DEM pin is the input for an external serial clock - this is known as the External Serial Clock
Mode. To enable de-emphasis selection, the Internal Serial Clock Mode has to be used. Sections 4.4.1
and 4.4.2 describe this feature in detail.
4.4.1
External Serial Clock Mode
The CS4354 will enter the External Serial Clock Mode when 16 low to high transitions are detected on the
DEM/SCLK pin during any phase of the LRCK period. When this mode is enabled, the Internal Serial
Clock Mode and de-emphasis filter are disabled (see Figure 9 for flow diagram).
In the External Serial Clock Mode, the CS4354 will support I²S data up to 24-bit, with data valid on the
rising edge of SCLK.
4.4.2
Internal Serial Clock Mode
The CS4354 will switch to Internal Serial Clock Mode if no low to high transitions are detected on the
DEM/SCLK pin for 2 consecutive frames of LRCK (see Figure 9 for flow diagram). In the Internal Serial
Clock Mode, the serial clock is internally derived and synchronous with MCLK and LRCK. The
SCLK/LRCK frequency ratio is either 32, 48, or 64 depending on the speed mode and MCLK frequency.
Operation in this mode is identical to operation with an external serial clock synchronized with LRCK. This
mode allows access to the digital de-emphasis function. Refer to Table 5 for details (all frequencies listed
as multiples of LRCK frequency).
Speed Mode
SSM
DSM
QSM
MCLK =
128x
-
-
-
192x
-
48x
32x
256x
64x
-
32x
384x
48x
-
-
512x
64x
-
-
768x
64x
-
-
1024x
64x
-
-
Table 5. Internal SCLK Frequencies
4.4.2.1 De-Emphasis Control
The device includes on-chip digital de-emphasis. Figure 7 shows the de-emphasis curve for Fs equal to
44.1 kHz. The frequency response of the de-emphasis curve scales with changes in the sample rate, Fs.
The de-emphasis error will increase for sample rates other than 44.1 kHz.
When the SCLK/DEM pin is connected to VL (internal SCLK mode), the 44.1 kHz de-emphasis filter is
activated. When the SCLK/DEM pin is connected to GND, the de-emphasis filter is disabled. For more
information see “Internal Serial Clock Mode” on page 14.
14
DS895A2