CS4354 Datasheet, PDF (11/25 Pages) Cirrus Logic – 5 V Stereo DAC with 2 VRMS Ground-centered Output

CS4354
DC ELECTRICAL CHARACTERISTICS
Test conditions (unless otherwise specified): VA = 5 V, VL = 3.3 V; GND = 0 V; SDIN = 0; all voltages with respect
to ground.
Parameters
Symbol Min
Typ
Max Units
Power Supplies
Power Supply Current (Note 15)
Power Dissipation (All Supplies)
(Note 15)
Normal Operation (Note 16)
I_VA
I_VL
Power-Down (Note 17)
I_VA
I_VL
Normal Operation (Note 16)
Power-Down (Note 17)
-
10
13
mA
-
0.1
0.2
mA
-
0.5
-
mA
-
1
-
A
-
50
65
mW
-
2.5
-
mW
Power Supply Rejection Ratio (Note 18)
(1 kHz) PSRR
-
60
-
dB
(60 Hz)
-
60
-
dB
DC Output Voltages
Pin Voltage
FILT+ to GND
FLYP to FLYN
GND to -VFILT
-
3.5
-
V
-
4.9
-
V
-
4.7
-
V
Notes: 15. Power supply current increases with increasing sample rate and increasing MCLK frequency. Typical
values are based on Fs = 48 kHz and MCLK = 12.288 MHz. Maximum values are based on highest
sample rate and highest MCLK frequency; see Switching Specifications - Serial Audio Interface. Vari-
ance between speed modes is small.
16. During normal operation, SDIN = 997 Hz sine wave at 0 dBFS with load resistance R_L = 3 k.
17. Power-down is defined as all clock and data lines held static low. All digital inputs have a weak pull-
down (approximately 50 k) which is only present during power on reset. Opposing this pull-down will
increase the power-down current.
18. Valid with the recommended capacitor values as shown in the typical connection diagram in Section 5.
2.1 Digital I/O Pin Characteristics
Input and output levels and associated power supply voltage are shown in Table 2. Logic levels should not
exceed the corresponding power supply voltage.
Pin Name
MCLK
LRCK
SCLK
SDIN
Power Supply
VL
VL
VL
VL
I/O
Input
Input
Input
Input
Driver
-
-
-
-
Receiver
1.8 V - 5 V
1.8 V - 5 V
1.8 V - 5 V
1.8 V - 5 V
Table 2. Digital I/O Pin Characteristics
DS895A2
11