AKD4753-A Datasheet, PDF (30/60 Pages) Asahi Kasei Microsystems – AK4753 Evaluation Board Rev.2

[AKD4753-A]
(2)Input sequence
[Address] : Data address
[Data] : Writing data
[Mask] : Mask
[Data] box data is ANDed with [Mask] box data. This is the actual writing data.
When Mask = 0x00, current setting is hold.
When Mask = 0xFF, the 8bit data which is set in the [Data] box is written.
When Mask =0x0F, lower 4bit data which is set in the [Data] box is written.
Upper 4bit is hold to current setting.
[Interval] : Interval time
Valid boxes for each process command are shown bellow.
· No use
· Register
· Reg(Mask)
· Interval
· Stop
· End
: None
: [Address], [Data], [Interval]
: [Address], [Data], [Mask], [Interval]
: [Interval]
: None
: None
3-2. Control Buttons
The function of Control Button is shown bellow.
[Start]
[Help]
[Save]
[Open]
[Close]
: Executing the sequence
: Opening a help window
: Saving sequence settings as a file. The file name is “*.aks”.
: Opening a sequence setting file “*.aks”.
: Closing the dialog box and finish the process.
3-3. Stop of the sequence
When “Stop” is selected in the sequence, processing is paused and it starts again when [Start] button is
clicked. Restarting step number is shown in the “Start Step” box. When finishing the process until the end of
sequence, “Start Step” will return to “1”.
The sequence can be started from any step by writing the step number to the “Start Step” box.
Write “1” to the “Start Step” box and click [Start] button, when restarting the process from the beginning.
KM103902
- 30 -
2011/01