AKD4128A-A Datasheet, PDF (26/52 Pages) Asahi Kasei Microsystems – AK4128A-A Evaluation Board Rev.0

[Sequence]
Click [Sequence] button to open register sequence setting dialog box.
Register sequence can be set in this dialog box.
[AKD4128A-A]


Figure 6. Window of [ Sequence ]
Sequence Setting
Set register sequence by following process bellow.
(1)Select a command
Use [Select] pull-down box to choose commands.
Corresponding boxes will be valid.
< Select Pull-down menu >
· No_use : Not using this address
· Register : Register writing
· Reg(Mask) : Register writing (Masked)
· Interval : Taking an interval
· Stop
: Pausing the sequence
· End
: Finishing the sequence
(2)Input sequence
[Address]
[Data]
[Mask]
[ Interval ]
: Data address
: Writing data
: Mask
[Data] box data is ANDed with [Mask] box data. This is the actual writing data.
When Mask = 0x00, current setting is hold.
When Mask = 0xFF, the 8bit data which is set in the [Data] box is written.
When Mask =0x0F, lower 4bit data which is set in the [Data] box is written.
Upper 4bit is hold to current setting.
: Interval time
[KM104301]
- 26 -
2010/09