AK4564 Datasheet, PDF (22/48 Pages) Asahi Kasei Microsystems – 16BIT CODEC WITH BUILT-IN ALC AND MIC/HP/SPK-AMP

ASAHI KASEI
[AK4564]
Headphone-Amps are powered-up/down by HPP bit. When HPP bit is “0”, Headphone-Amps are powered-down and
HPL and HPR pins are fixed to “L” (AVSS). At power-up/down, the common voltage of HPL/HPR pin is settled by a
constant which determined by the internal resistor and the external capacitors. The internal resistor is 50kΩ(typ) at
power-up, and 1kΩ(typ) at power-down. (Refer to Figure 16)
Rising Time of Headphone-Amp: τ1 = 50kΩ x C1
Falling Time of Headphone-Amp: τ2= 1kΩ x (C1 + 2 x C2)
For example; C1 = 4.7µF, C2 = 100µF
τ1 = 235ms
τ2 = 205ms
HPMIX bit
From MIX1
HP-Amp
HPL, HPR
HPDAC bit
From DAC
-
16Ω
C2
+
BEEP2H bit
+
From BEEP2
MUTET
16Ω
+
C1
Figure 16. Headphone-Amp internal equivalent circuit
HPP bit
HPDAC, HPMIX or BEEP2H bit
τ2
HPL/HPR pin
τ1
(1) (2)
(3) (4)
Figure 17. Headphone-Amp Power-Up/Down Timing
(1) Power-up Headphone-Amps: WR (HPP= “1”)
The common voltage of HPL/HPR pins rises by the time constant. (τ1)
(2) Enable Headphone-Amp inputs: WR (HPDAC, HPMIX or BEEP2H =“1”)
The input signals from MIX1, DAC and BEEP2 are output. Headphone-Amps can output the signals while the
common voltage is rising.
(3) Disable Headphone-Amp inputs: WR (HPDAC=HPMIX=BEEP2H=“0”)
The input signal from MIX1, DAC and BEEP2 are muted. Headphone-Amps output HVCM voltage during muting.
(4) Power-down Headphone-Amps: WR (HPP=“0”)
The common voltage of HPL/HPR pins falls by the time constant. (τ2)
MS0140-E-01
- 22 -
2002/07