Z86E04 Datasheet, PDF (6/44 Pages) Zilog, Inc. – CMOS Z8 OTP MICROCONTROLLERS

Z86E04/E08
CMOS Z8 OTP Microcontrollers
ABSOLUTE MAXIMUM RATINGS
Stresses greater than those listed under Absolute Maxi-
mum Ratings may cause permanent damage to the de-
vice. This is a stress rating only; functional operation of the
device at any condition above those indicated in the oper-
ational sections of these specifications is not implied. Ex-
posure to absolute maximum rating conditions for an ex-
tended period may affect device reliability. Total power
Zilog
dissipation should not exceed 462 mW for the package.
Power dissipation is calculated as follows:
Total Power Dissipation =
V_DD x [I_DD–(sum of I_OH)]
+ sum of [(V_DD–V_OH) x I_OH]
+ sum of (V_0L x I_0L)
Parameter
Min
Max
Ambient Temperature under Bias
–40
+105
Storage Temperature
Voltage on any Pin with Respect to V_SS
Voltage on V_DD Pin with Respect to V_SS
Voltage on Pins 7, 8, 9, 10 with Respect to V_SS
Total Power Dissipation
Maximum Allowable Current out of V_SS
Maximum Allowable Current into V_DD
Maximum Allowable Current into an Input Pin
Maximum Allowable Current into an Open-Drain Pin
Maximum Allowable Output Current Sinked by Any I/O Pin
Maximum Allowable Output Current Sourced by Any I/O Pin
Total Maximum Output Current Sinked by a Port
–65
–0.7
–0.3
–0.6
–600
–600
+150
+12
+7
V_DD+1
1.65
300
220
+600
+600
25
25
60
Total Maximum Output Current Sourced by a Port
45
Notes:
1. This applies to all pins except where otherwise noted. Maximum current into pin must be ± 600 µA.
2. There is no input protection diode from pin to V_DD(not applicable to EPROM Mode).
3. This excludes Pin 6 and Pin 7.
4. Device pin is not at an output Low state.
Units
C
C
V
V
V
W
mA
mA
µA
µA
mA
mA
mA
mA
Note
1
2
3
4
6
PRELIMINARY
DS97Z8X1104