Z8F64820100ZCOG Datasheet, PDF (47/48 Pages) Zilog, Inc. – Power to the Board with overcurrent protection

Z8 Encore! XP^® F6482 Series Development Kit
User Manual
39
Appendix C. Tera Term Configuration
If you are using Tera Term as your console program, observe the following procedure to
properly configure it.
1. Please refer to page 12 section Hyper Terminal Configuration on how to connect a
USB to TTL serial converter between the development board and your host PC.
2. In Tera Term, and if your PC has a serial interface, navigate via the Setup menu to
Serial port… to select the COM port assigned to your serial port. If you do not have a
serial port on your PC, use a USB-to-serial adapter (not included in the kit).
3. Use the Ports (COM & LPT) listing in the Device Manager to determine the correct
COM port assigned to your adapter. Configure this port to reflect the following set-
tings:
– 57600 bps
– 8 data bits
– No parity
– 1 stop bit
– No flow control
4. Click the OK button to connect to the F6482 Development Board. Upon connection,
you should be able to see the demonstration program menu shown in Figure 11 on
page 12.
UM026302-0916
Tera Term Configuration