Z8F64820100ZCOG Datasheet, PDF (18/48 Pages) Zilog, Inc. – Power to the Board with overcurrent protection

Z8 Encore! XP^® F6482 Series Development Kit
User Manual
10
4. From the Build menu, select Set Active Configuration to open the Select Configura-
tion dialog box.
5. Select Debug, then click OK to close the Select Configuration dialog box.
6. From the Project menu in ZDSII, select Settings to open the Project Settings dialog
box. In the Project Settings dialog box, click the Debugger tab.
7. On the Debugger page, select Z8F64820100ZCOG from the Target list, then select
USB SmartCable from the Debug Tool drop-down menu, as shown in Figure 8.
Figure 8. Select Z8F64820100ZCOG and USB SmartCable
8. Click OK to close the Project Settings dialog box.
9. If you are prompted to rebuild any affected files, click Yes. Otherwise, choose Build
from the menu bar, then click Rebuild All.
10. To run the application, select Go from the Debug menu, as indicated in Figure 9. As a
result, LEDs D4, D5, and D6 will blink in sequence.
The Z8 Encore! XP^® F6482 Series Development Kit
UM026302-0916