Z8F64820100ZCOG Datasheet, PDF (14/48 Pages) Zilog, Inc. – Power to the Board with overcurrent protection

Z8 Encore! XP^® F6482 Series Development Kit
User Manual
6
Connect the F6482 Series Development Board to your PC
Observe the following procedure to connect the F6482 Series Development Board to your
PC.
Caution: Disconnect or turn off the power to the F6482 Series Development Board before con-
necting or disconnecting the USB SmartCable.
1. Ensure that the following F6482 Series Development board default jumper settings
are configured (see Table 5 on page 31 for reference):
J1 IN
J2 OUT
J9 IN
J19 OUT
J21 1-2 IN
J21 5-6 IN
J23 1-2 IN
2. Connect one end of the 6-circuit ribbon cable provided in your Kit to the USB Smart-
Cable unit, ensuring that the ribbon’s male connector is aligned correctly with the
female connector on the unit, as indicated by the red stripe in Figure 3.
Figure 3. Connecting the 6-Circuit Ribbon Cable to the USB SmartCable
The Z8 Encore! XP^® F6482 Series Development Kit
UM026302-0916