W741E260 Datasheet, PDF (7/94 Pages) Winbond – 4-BIT FLASH MICROCONTROLLER

W741E260
FUNCTIONAL DESCRIPTION
Program Counter (PC)
Organized as an 11-bit binary counter (PC0 to PC10), the program counter generates the addresses
ofthe 2048 × 16 on-chip flash EEPROM containing the program instruction. When the jump or
subroutine call instructions or the interrupt or initial reset conditions are to be executed, the address
corresponding to the instruction will be loaded into the program counter. The format used is shown
below.
ITEM
ADDRESS
INTERRUPT PRIORITY
Initial Reset
000H
-
INT 0 (Divider0)
004H
1st
INT 1 (Timer 0)
008H
2nd
INT 2 (Port RC)
00CH
3rd
INT 3 (Divider1 for W741C260;
014H
4th
INT ^{pin for W741C250)}
INT 4 (Timer 1)
020H
5th
JMP Instruction
XXXH
-
Subroutine Call
XXXH
-
Stack Register (STACK)
The stack register is organized as 11-bit x 8 levels (first-in, last-out). When either a call subroutine or
an interrupt is executed, the program counter will be pushed onto the stack register automatically. At
the end of a call subroutine or an interrupt service subroutine, the RTN instruction must be executed to
pop the contents of the stack register into the program counter. When the stack register is pushed over
the eighth level, the contents of the first level will be lost. In other words, the stack register is always
eight levels deep.
Program Memory (flash EEPROM)
The flash EEPROM is used to store program codes; the look-up table is arranged as 2048 × 4 bits.
The first three quarters of flash EEPROM (000H to 5FFH) are used to store instruction codes only, but
the last quarter (600H to 7FFH) can store both instruction codes and the look-up table. Each look-up
table element is composed of 4 bits, so the look-up table can be addressed up to 2048 elements.
There are two registers (TABL and TABH) to be used in look-up table addressing and they are
controlled by MOV TABH, R and MOV TABL, R instructions. When the instruction MOVC R is
executed, the contents of the look-up table location address specified by TABH, TABL and ACC will
be read and transferred to the data RAM. Refer to the instruction table for more details. The
organization of the program memory is shown in Figure 1.
Publication Release Date: March 1998
-7-
Revision A2