W83697HF_05 Datasheet, PDF (67/102 Pages) Winbond – LPC I/O

W83697HF
CR26 (Default 0x00)
Bit 7: SEL4FDD
= 0 Select two FDD mode.
= 1 Select four FDD mode.
Bit 6: HEFRAS
These two bits define how to enable Configuration mode. The corresponding power-on
setting pin is RTSA #(pin 49).
HEFRAS Address and Value
= 0 Write 87h to the location 2E twice.
= 1 Write 87h to the location 4Etwice.
Bit 5: LOCKREG
= 0 Enable R/W Configuration Registers.
= 1 Disable R/W Configuration Registers.
Bit4: Reserved
Bit 3: DSFDLGRQ
= 0 Enable FDC legacy mode on IRQ and DRQ selection, then DO register bit 3 is effective
on selecting IRQ
= 1 Disable FDC legacy mode on IRQ and DRQ selection, then DO register bit 3 is not
effective on selecting IRQ
Bit 2: DSPRLGRQ
= 0 Enable PRT legacy mode on IRQ and DRQ selection, then DCR bit 4 is effective on
selecting IRQ
= 1 Disable PRT legacy mode on IRQ and DRQ selection, then DCR bit 4 is not effective on
selecting IRQ
Bit 1: DSUALGRQ
= 0Enable UART A legacy mode IRQ selecting, then MCR bit 3 is effective on selecting IRQ
= 1Disable UART A legacy mode IRQ selecting, then MCR bit 3 is not effective on selecting
IRQ
Bit 0: DSUBLGRQ
= 0 Enable UART B legacy mode IRQ selecting, then MCR bit 3 is effective on selecting IRQ
= 1 Disable UART B legacy mode IRQ selecting, then MCR bit 3 is not effective on selecting
IRQ
- 64 -