|
W972GG6JB Datasheet, PDF (46/87 Pages) Winbond – 16M 8 BANKS 16 BIT DDR2 SDRAM | |||
|
◁ |
W972GG6JB
AC Characteristics and Operating Condition for -25/25I/25A/25K/-3/-3A speed grades, continued
Notes: 1-3 and 45-47 apply to the entire table
SYM.
tWPRE
tWPST
tRPRE
tRPST
SPEED GRADE
Bin(CL-tRCD-tRP)
PARAMETER
Write preamble
Write postamble
Read preamble
Read postamble
DDR2-800
(-25/25I/25A/25K)
5-5-5/6-6-6
MIN.
MAX.
0.35
ï
0.4
0.6
0.9
1.1
0.4
0.6
DDR2-667
(-3/-3A)
5-5-5
MIN.
MAX.
0.35
ï
0.4
0.6
0.9
1.1
0.4
0.6
tDS(base) DQ and DM input setup time
50
ï
100
ï
tDH(base) DQ and DM input hold time
125
ï
175
ï
tDS(ref) DQ and DM input setup time
250
ï
300
ï
tDH(ref) DQ and DM input hold time
tDIPW
tHZ
DQ and DM input pulse width for each
input
Data-out high-impedance time from
CLK/ CLK
250
0.35
ï
ï
ï
tAC,max
300
0.35
ï
ï
ï
tAC,max
UNITS25 NOTES
tCK(avg)
tCK(avg) 12
tCK(avg) 14,36
tCK(avg) 14,37
pS
16,27,29,
41,42,44
pS
17,27,29,
41,42,44
pS
16,27,29,
41,42,44
pS
17,27,29,
41,42,44
tCK(avg)
pS 15,35
DQS/ DQS -low-impedance time from
tLZ(DQS)
CLK/ CLK
tAC,min
tAC,max
tAC,min
tAC,max
pS 15,35
tLZ(DQ) DQ low-impedance time from CLK/ CLK 2 x tAC,min tAC,max 2 x tAC,min tAC,max
pS 15,35
tHP Clock half pulse width
Min.
(tCH(abs),
tCL(abs))
Min.
(tCH(abs),
tCL(abs))
pS
32
tQHS Data hold skew factor
ï
300
ï
340
pS
33
tQH DQ/DQS output hold time from DQS
tHP - tQHS
ï
tHP - tQHS
ï
pS
34
tXSNR Exit Self Refresh to a non-Read command tRFC + 10
ï
tRFC + 10
ï
nS
23
tXSRD Exit Self Refresh to a Read command
200
ï
200
ï
nCK
tXP
Exit precharge power down to any
command
2
ï
2
ï
nCK
tXARD Exit active power down to Read command
2
ï
2
ï
nCK
18
Exit active power down to Read command
tXARDS (slow exit, lower power)
8 - AL
ï
7 - AL
ï
nCK 18,19
tAOND ODT turn-on delay
2
2
2
2
nCK
20
tAON ODT turn-on
tAC,min tAC,max + 0.7 tAC,min tAC,max + 0.7 nS
20,35
tAONPD ODT turn-on (Power Down mode)
tAC,min + 2
2 x tCK(avg) +
tAC,max + 1
tAC,min + 2
2 x tCK(avg) +
tAC,max + 1
nS
tAOFD ODT turn-off delay
2.5
2.5
2.5
2.5
nCK 21,39
tAOF ODT turn-off
tAC,min tAC,max + 0.6 tAC,min tAC,max + 0.6 nS 21,38,39
tAOFPD ODT turn-off (Power Down mode)
tAC,min + 2
2.5 x tCK(avg)
+ tAC,max + 1
tAC,min + 2
2.5 x tCK(avg)
+ tAC,max + 1
nS
tANPD ODT to power down Entry Latency
3
ï
3
ï
nCK
tAXPD ODT Power Down Exit Latency
8
8
nCK
tMRD Mode Register Set command cycle time
2
ï
2
ï
nCK
tMOD MRS command to ODT update delay
0
12
0
12
nS
23
tOIT OCD Drive mode output delay
0
12
0
12
nS
23
tDELAY
Minimum time clocks remain ON after
CKE asynchronously drops LOW
tIS+tCK(avg)+
tIH
ï
tIS+tCK(avg)+
tIH
ï
nS
22
- 46 -
Publication Release Date: Nov. 29, 2011
Revision A02
|
▷ |