W77C32_07 Datasheet, PDF (40/78 Pages) Winbond – 8-BIT MICROCONTROLLER

W77C32/W77C032A
Last Cycle
of Previous
Instruction
First
Machine Cycle
Second
Machine Cycle
Third
Machine Cycle
Fourth
Next
Machine Cycle ^Instruction
Machine Cycle
MOVX instruction cycle
C1 C2 C3 C4 C1 C2 C3 C4 C1 C2 C3 C4 C1 C2 C3 C4 C1 C2 C3 C4 C1 C2 C3 C4
CLK
ALE
PSEN
WR
PORT 0
A0-A7
D0-D7 A0-A7
D0-D7 A0-A7
D0-D7
A0-A7
D0-D7
PORT 2
MOVX Inst.
Address
Next Inst.
Address
MOVX Data
Address
MOVX Inst.
Next Inst.
Read
A15-A8
A15-A8
MOVX Data out
A15-A8
A15-A8
Figure 10: Dada Memory Write with Stretch Value = 2
8.4 Wait State Control Signal
Either with the software using stretch value to change the required machine cycle of MOVX
instruction, the W77C032 provides another hardware signal WAIT to implement the wider duration of
external data access timing. This wait state control signal is the alternate function of P4.0 such that it
can only be invoked to 44-pin PLCC/QFP package type. The wait state control signal can be enabled
by setting WS (ROMMAP.7) bit. When enabled, the setting of stretch value decides the minimum
length of MOVX instruction cycle and the device will sample the WAIT pin at each C3 state before the
rising edge of read/write strobe signal during MOVX instruction. Once this signal being recongnized,
one more machine cycle (wait state cycle) will be inserted into next cycle. The inserted wait state
cycles are unlimited, so the MOVX instruction cycle will end in which the wait state control signal is
deactivated. Using wait state control signal allows a dynamically access timimg to a selected external
peripheral. The WS bit is accessed by the Timed Access Protection procedure.
- 40 -