W77C32_07 Datasheet, PDF (16/78 Pages) Winbond – 8-BIT MICROCONTROLLER

W77C32/W77C032A
7.1 External Interrupt Flag
Bit:
7
6
5
4
3
2
1
0
IE5
IE4
IE3
IE2 XT/RG _RGMD RGSL BGS
Mnemonic: EXIF
Address: 91h
IE5: External Interrupt 5 flag. Set by hardware when a falling edge is detected on INT5 .
IE4: External Interrupt 4 flag. Set by hardware when a rising edge is detected on INT4.
IE3: External Interrupt 3 flag. Set by hardware when a falling edge is detected on INT5 .
IE2: External Interrupt 2 flag. Set by hardware when a rising edge is detected on INT2.
XT/ RG RG: Crystal/RC Oscillator Select. Setting this bit selects crystal or external clock as system
clock source. Clearing this bit selects the on-chip RC oscillator as clock source.
XTUP(STATUS.4) must be set to 1 and XTOFF (PMR.3) must be cleared before this bit can
be set. Attempts to set this bit without obeying these conditions will be ignored. This bit is set
to 1 after a power-on reset and unchanged by other forms of reset.
RGMD: RC Mode Status. This bit indicates the current clock source of microcontroller. When cleared,
CPU is operating from the external crystal or oscillator. When set, CPU is operating from the
on-chip RC oscillator. This bit is cleared to 0 after a power-on reset and unchanged by other
forms of reset.
RGSL: RC Oscillator Select. This bit selects the clock source following a resume from Power Down
Mode. Setting this bit allows device operating from RC oscillator when a resume from Power
Down Mode. When this bit is cleared, the device will hold operation until the crystal oscillator
has warmed-up following a resume from Power Down Mode. This bit is cleared to 0 after a
power-on reset and unchanged by other forms of reset.
Serial Port Control
Bit:
7
6
5
4
3
2
1
0
SM0/FE SM1 SM2 REN TB8 RB8 TI
RI
Mnemonic: SCON
Address: 98h
SM0/FE: Serial port 0, Mode 0 bit or Framing Error Flag: The SMOD0 bit in PCON SFR determines
whether this bit acts as SM0 or as FE. The operation of SM0 is described below. When used
as FE, this bit will be set to indicate an invalid stop bit. This bit must be manually cleared in
software to clear the FE condition.
SM1: Serial port Mode bit 1:
SM0
0
0
1
1
SM1
0
1
0
1
Mode
0
1
2
3
Description
Synchronous
Asynchronous
Asynchronous
Asynchronous
Length
8
10
11
11
Baud rate
4/12 Tclk
variable
64/32 Tclk
variable
- 16 -