English
Language : 

W25Q32JVTBIQ-TR Datasheet, PDF (10/76 Pages) Winbond – 3V 32M-BIT SERIAL FLASH MEMORY WITH DUAL, QUAD SPI
W25Q32JV
4. PIN DESCRIPTIONS
4.1 Chip Select (/CS)
The SPI Chip Select (/CS) pin enables and disables device operation. When /CS is high the device is
deselected and the Serial Data Output (DO, or IO0, IO1, IO2, IO3) pins are at high impedance. When
deselected, the devices power consumption will be at standby levels unless an internal erase, program or
write status register cycle is in progress. When /CS is brought low the device will be selected, power
consumption will increase to active levels and instructions can be written to and data read from the device.
After power-up, /CS must transition from high to low before a new instruction will be accepted. The /CS
input must track the VCC supply level at power-up and power-down (see “Write Protection” and Figure 58).
If needed a pull-up resister on the /CS pin can be used to accomplish this.
4.2 Serial Data Input, Output and IOs (DI, DO and IO0, IO1, IO2, IO3)
The W25Q32JV supports Standard SPI, Dual SPI and Quad SPI operation in each individual stacked die.
All 8-bit instructions are shifted into the device through DI (IO0) pin, address and data are shifted in and out
of the device through either DI & DO pins for Standard SPI instructions, IO0 & IO1 pins for Dual SPI
instructions, or IO0-IO3 pins for Quad SPI instructions.
4.3 Serial Clock (CLK)
The SPI Serial Clock Input (CLK) pin provides the timing for serial input and output operations. ("See SPI
Operations")
4.4 Reset (/RESET)(1)
A dedicated hardware /RESET pin is available on SOIC-16 and TFBGA packages. When it’s driven low for
a minimum period of ~1µS, this device will terminate any external or internal operations and return to its
power-on state.
Note:
1. Hardware /RESET pin is available on SOIC-16 or TFBGA; please contact Winbond for this package.
-9-