English
Language : 

BCM4414XD1E13A2YZZ Datasheet, PDF (36/42 Pages) Vicor Corporation – Isolated Fixed-Ratio DC-DC Converter
BCM4414xD1E13A2yzz
READ_K_FACTOR Command (D1h)
If PAGE data byte is equal to (01h - 04h), command will return a
reported individual BCM’s K factor in the following format:
K_FACTORACTUAL = K_FACTORREPORTED • 2 -16(V/V)
The K factor is defined in a BCM to represent the ratio of the
transformer winding and hence is equal to VLO / VHI.
READ_BCM_ROUT Command (D4h)
If PAGE data byte is equal to (01h - 04h), command will return
a reported individual BCM’s LO side resistance in the following
format:
BCM_RLO_ACTUAL = BCM_RLO_REPORTED • 10 -5(Ω)
SET_ALL_THRESHOLDS Command (D5h)
SET_ALL_THRESHOLDS_BLOCK (6 Bytes)
IOUT_OC_WARN_ LIMIT
IOUT_OC_FAULT_ LIMIT
VIN_OV_WARN_ LIMIT
VIN_OV_FAULT_ LIMIT
OT_WARN_LIMIT
OT_FAULT_LIMIT
543210
64 64 64 64 64 64 h
DISABLE_FAULT Command (D7h)
MSB
DISABLE_FAULT
LSB
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
VIN_UV_FAULT
Reserved
Reserved
Reserved
IOUT_OC_FAULT
Reserved
VIN_OV_FAULT
Reserved
Reserved
Reserved
7 6 5 4 3 2 1 07 6 5 4 3 2 1 0
0100000000101000 b
Unsupported bits are indicated above. A one indicates that the
supervisory fault associated with the asserted bit is disabled.
The values of this register block are set in non-volatile memory and
can only be written when the BCMs are disabled.
This command allows the host to disable the supervisory faults
and respective statuses. It does not disable the powertrain analog
protections or warnings with respect to the set limits in the SET_
ALL_THRESHOLDS Command.
The HI side undervoltage can only be disabled to a pre-set low limit
as shown in the functional reporting range in the BCM data sheet.
The values of this register block are set in non-volatile memory and
can only be written when the BCMs are disabled.
This command provides a convenient way to configure all of the
limits, or any combination of limits described previously using one
command.
VHI overvoltage, overcurrent and overtemperature values are all set
to 100% of the specified supervisory limits by default and can only
be set to a lower percentage.
To leave a particular threshold unchanged, set the corresponding
threshold data byte to a value greater than (64h).
BCM® in a VIA Package
Page 36 of 42
Rev 1.5
10/2016
vicorpower.com
800 927.9474