MSP43020X3 Datasheet, PDF (78/92 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430F20x3
MSP430F20x2
MSP430F20x1
SLAS491H – AUGUST 2005 – REVISED AUGUST 2011
REVISION HISTORY
www.ti.com
LITERATURE
NUMBER
SLAS491
SLAS491A
SLAS491B
SLAS491C
SLAS491D
SLAS491E
SLAS491F
SLAS491G
SLAS491H
SUMMARY
Preliminary PRODUCT PREVIEW data sheet release
Production data sheet release for MSP430F20x3I.
Updated specification and added characterization graphs.
Production data sheet release for MSP430F20x3T, MSP430F20x1I and MSP430F20x1T.
105°C characterization results added.
SD16_A SINAD characterization results for MSP430F20x3.
RSA package added.
Updated SD16_A Power Supply Rejection specification.
DCO Calibration Register names: lower case "z" changed to upper case "Z".
V_{hys(B_IT-)} MAX specification increased from 180 mV to 210 mV.
MIN and MAX percentages for "calibrated DCO frequencies - tolerance over supply voltage VCC" corrected from 2.5% to
3.0% to match the specified frequency ranges.
Production data sheet release for MSP430F20x2I and MSP430F20x2T.
Changed f_ACLK to 0 Hz in I_LPM4 test conditions on page 23.
Changed T_stg maximum for programmed devices to 150°C (page 20)
Added ADC10 data transfer registers to Peripheral File Map (page 18, 19)
Changed Test Conditions for "Duty cycle, LF mode" in Crystal Oscillator, XT1, Low-Frequency Mode.
Changed note (1) on 10-Bit ADC, Built-In Voltage Reference.
Changed USIP.x Control Bits in Table 25 and Table 29.
Changed T_stg, Programmed device, to -55°C to 150°C in Absolute Maximum Ratings.
78
Copyright © 2005–2011, Texas Instruments Incorporated