CC1310_16 Datasheet, PDF (31/54 Pages) Texas Instruments – SimpleLink Ultralow Power Sub-1-GHz Wireless MCU

www.ti.com
CC1310
SWRS181B – SEPTEMBER 2015 – REVISED OCTOBER 2015
Table 6-1. GPIOs Connected to the Sensor Controller⁽¹⁾
ANALOG CAPABLE
7 × 7 RGZ
DIO NUMBER
5 × 5 RHB
DIO NUMBER
4 × 4 RSM
DIO NUMBER
Y
30
14
Y
29
13
Y
28
12
Y
27
11
9
Y
26
9
8
Y
25
10
7
Y
24
8
6
Y
23
7
5
N
7
4
2
N
6
3
1
N
5
2
0
N
4
1
N
3
0
N
2
N
1
N
0
(1) Depending on the package size, up to 15 pins can be connected to the Sensor Controller. Up to 8 of
these pins can be connected to analog modules.
6.5 Memory
The flash memory provides nonvolatile storage for code and data. The flash memory is in-system
programmable.
The SRAM (static RAM) is split into two 4-KB blocks and two 6-KB blocks and can be used for both
storage of data and execution of code. Retention of the RAM contents in standby mode can be enabled or
disabled individually for each block to minimize power consumption. In addition, if flash cache is disabled,
the 8-KB cache can be used as a general-purpose RAM.
The ROM provides preprogrammed, embedded TI RTOS kernel and Driverlib. It also contains a
bootloader that can be used to reprogram the device using SPI or UART.
6.6 Debug
The on-chip debug support is done through a dedicated cJTAG (IEEE 1149.7) or JTAG (IEEE 1149.1)
interface.
Copyright © 2015, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: CC1310
Detailed Description
31