DS90UR903Q Datasheet, PDF (26/34 Pages) Texas Instruments – DS90UR903Q/DS90UR904Q 10 - 43MHz 18 Bit Color FPD-Link II Serializer and Deserializer

The High Speed Serial Channel is a 28-bit symbol composed
of 21 bits of data containing video data & control information
transmitted from Serializer to Deserializer. CLK1 and CLK0
represent the embedded clock in the serial stream. CLK1 is
always HIGH and CLK0 is always LOW. This data payload is
optimized for signal transmission over an AC coupled link.
Data is randomized, balanced and scrambled.
DESCRIPTION OF SERIAL CONTROL BUS
ID[X] ADDRESS DECODER
The ID[x] pin is used to decode and set the physical slave
address of the Serializer/Deserializer (I²C only) to allow up to
six devices on the bus using only a single pin. The pin sets
one of six possible addresses for each Serializer/Deserializer
device. The pin must be pulled to VDD (1.8V, NOT VDDIO))
with a 10 kΩ resistor and a pull down resistor (RID) of the
recommended value to set the physical device address. The
recommended maximum resistor tolerance is 0.1% worst
case (0.2% total tolerance).
FIGURE 24. Serial Control Bus Connection
30164643
TABLE 3. ID[x] Resistor Value – DS90UR903Q
ID[x] Resistor Value - DS90UR903Q Ser
Resistor
RID Ω
(±0.1%)
Address 7'b
(Note 11)
Address 8'b 0
appended (WRITE)
0
GND
7b' 101 1000 (h'58) 8b' 1011 0000 (h'B0)
2.0k 7b' 101 1001 (h'59) 8b' 1011 0010 (h'B2)
4.7k 7b' 101 1010 (h'5A) 8b' 1011 0100 (h'B4)
8.2k 7b' 101 1011 (h'5B) 8b' 1011 0110 (h'B6)
12.1k 7b' 101 1100 (h'5C) 8b' 1011 1000 (h'B8)
39.0k 7b' 101 1110 (h'5E) 8b' 1011 1100 (h'BC)
TABLE 4. ID[x] Resistor Value – DS90UR904Q
ID[x] Resistor Value - DS90UR904Q Des
Resistor
RID Ω
(±0.1%)
Address 7'b
(Note 11)
Address 8'b 0
appended (WRITE)
0
GND
7b' 110 0000 (h'60) 8b' 1100 0000 (h'C0)
2.0k 7b' 110 0001 (h'61) 8b' 1100 0010 (h'C2)
4.7k 7b' 110 0010 (h'62) 8b' 1100 0100 (h'C4)
8.2k 7b' 110 0011 (h'63) 8b' 1101 0110 (h'C6)
12.1k 7b' 110 0100 (h'64) 8b' 1101 1000 (h'C8)
39.0k 7b' 110 0110 (h'66) 8b' 1100 1100 (h'CC)
25
www.national.com