DS80PCI800SQ Datasheet, PDF (24/45 Pages) Texas Instruments – DS80PCI800 2.5 Gbps / 5.0 Gbps / 8.0 Gbps 8 Channel PCI Express Repeater

DS80PCI800
SNLS334E – APRIL 2011 – REVISED MARCH 2012
www.ti.com
Address
0x08
Register Name
Override
Pin Control
0x0E
CH0 - CHB0
IDLE, RXDET
0x0F
0x10
CH0 - CHB0
EQ
CH0 - CHB0
VOD
Table 9. SMBUS Slave Mode Register Map (continued)
Bit (s) Field
7
Reserved
6
Override SD_TH
5
Reserved
4
Override IDLE
3
Override RXDET
2
Override RATE
1
Reserved
0
Reserved
7:6 Reserved
5
IDLE_AUTO
4
IDLE_SEL
3:2 RXDET
1:0 Reserved
7:0 EQ Control
7
Short Circuit
Protection
6
RATE_SEL
5:3 Reserved
2:0 VOD Control
Type Default
R/W 0x00
R/W 0x00
R/W 0x2F
R/W 0xAD
Description
Set bit to 0.
1: Block SD_TH pin control
0: Allow SD_TH pin control
Set bit to 0.
1: IDLE control by registers
0: IDLE control by signal detect
1: Block RXDET pin control
0: Allow RXDET pin control
1: Block RATE pin control
0: Allow RATE pin control
Set bit to 0.
Set bit to 0.
Set bits to 0.
1: Automatic IDLE detect
0: Allow IDLE_SEL control in bit 4
Note: override IDLE control.
1: Output is MUTED (electrical idle)
0: Output is ON
Note: override IDLE control.
00: Input is high-z impedance
01: Auto RX-Detect,
outputs test every 12 ms for 600 ms (50 times) then
stops; termination is high-z until detection; once
detected input termination is 50 Ω
10: Auto RX-Detect,
outputs test every 12 ms until detection occurs;
termination is high-z until detection; once detected
input termination is 50 Ω
11: Input is 50 Ω
Note: override RXDET pin.
Set bits to 0.
IB0 EQ Control - total of 256 levels.
See Table 2.
1: Enable the short circuit protection
0: Disable the short circuit protection
1: Gen 1/2,
0: Gen 3
Note: override the RATE pin.
Set bits to default value - 101.
OB0 VOD Control
000: 0.7 V
001: 0.8 V
010: 0.9 V
011: 1.0 V
100: 1.1 V
101: 1.2 V (default)
110: 1.3 V
111: 1.4 V
24
Submit Documentation Feedback
Product Folder Links: DS80PCI800
Copyright © 2011–2012, Texas Instruments Incorporated