DS90UB903Q Datasheet, PDF (23/41 Pages) Texas Instruments – 10 - 43MHz 18 Bit Color FPD-Link III Serializer and Deserializer with Bidirectional Control Channel

Addr
Name
Bits
Field
R/W
(Hex)
RESERVED 7:6 RESERVED
VDDIO Control
5
VDDIO
CONTROL
RW
VDDIO Mode
4 VDDIO MODE
RW
3 I²C Pass-Through 3 ^{I2C PASS-}
RW
THROUGH
Auto ACK
2 AUTO ACK
RW
RESERVED
1 RESERVED
RRFB
0 RRFB
RW
4
EQ Control
7:0 EQ
RW
5
RESERVED 7:0 RESERVED
RESERVED
7 RESERVED
SCL Prescale 6:4 SCL_PRESCALE RW
6
Remote NACK
3
REM_NACK_TIM
ER
RW
Remote NACK 2:0 NACK_TIMEOUT RW
Default
Description
11'b
1
0
1
0
0
1
0x00'h
0x00'h
0
000'b
1
111'b
Reserved
Auto voltage control
0: Disable
1: Enable (auto detect mode)
VDDIO voltage set
Only used when VDDIOCONTROL = 0
0: 1.8V
1: 3.3V
I²C Pass-Through Mode
0: Disabled
1: Enabled
0: Disable
1: Enable
Reserved
Pixel Clock Edge Select
0: Parallel Interface Data is strobed on the Falling Clock
Edge
1: Parallel Interface Data is strobed on the Rising Clock
Edge.
EQ Gain
00'h = ~0.0 dB
01'h = ~4.5 dB
03'h = ~6.5 dB
07'h = ~7.5 dB
0F'h = ~8.0 dB
1F'h = ~11.0 dB
3F'h = ~12.5 dB
FF'h = ~14.0 dB
Reserved
Reserved
Prescales the SCL clock line when reading data byte
from a slave device (MODE = 0)
000 : ~100 kHz SCL (default)
001 : ~125 kHz SCL
101 : ~11 kHz SCL
110 : ~33 kHz SCL
111 : ~50 kHz SCL
Other values are NOT supported.
Remote NACK Timer Enable
In slave mode (MODE = 1) if bit is set the I²C core will
automatically timeout when no acknowledge condition
was detected.
1: Enable
0: Disable
Remote NACK Timeout.
000: 2.0 ms
001: 5.2 ms
010: 8.6 ms
011: 11.8 ms
100: 14.4 ms
101: 18.4 ms
110: 21.6 ms
111: 25.0 ms
23
www.ti.com