LMH6586_14 Datasheet, PDF (22/34 Pages) Texas Instruments – 32x16 Video Crosspoint Switch

LMH6586
SNCS105D – JULY 2008 – REVISED MARCH 2013
www.ti.com
INPUT
(0-31)
32
75:
LMH6586
16
INPUT
(32-63)
32
INPUT
(64-95)
32
75:
LMH6586
16
75:
LMH6586
16
OUTPUT
(0-15)
INPUT
(96-127)
32
75:
LMH6586
16
Figure 53. 128 x 16 Crosspoint Array
DRIVING CAPACITIVE LOAD
When many outputs are wired together, as in the case of expansion, each output buffer sees the normal load
impedance as well as the impedance the other shutdown outputs. This impedance has a resistive and a
capacitive component. The resistive components reduce the total effective load for the driving output. Total
capacitance is the sum of the capacitance of all the outputs and depends on the size of the matrix. As the size of
the matrix increases, the length of the PC board traces also increases, adding more capacitance. The output
buffers have been designed to drive more than 30 pF of capacitance while still maintaining a good AC response.
If the output capacitance exceeds this amount then the AC response will be degraded. To prevent this, one
option is to reduce the number of output wired-or together by using more LMH6586 device. Another option is to
put a resistor in series with the output before the capacitive load to limit excessive ringing and oscillations.
A low pass filter is created from the series resistor (R) and parasitic capacitance (C) to ground. A single R-C
does not affect the performance at video frequencies, however, in large system, there may be many such R-Cs
cascaded in series. This may result in high frequency roll-off resulting in “softening of the picture”. There are two
solutions to improve performance in this case. One way is to design the PC board traces with some inductance
between the R and C elements. By routing the traces in a repeating “S” configuration, the traces that are nearest
each other will exhibit a mutual inductance increasing the total inductance. This series inductance causes the
amplitude response to increase or peak at higher frequencies, offsetting the roll-off from the parasitic
capacitance. Another solution is to add a small-value inductor between the R and C elements to add peaking to
the frequency response.
THERMAL MANAGEMENT
The LMH6586 operates on a 5V supply and draws a load current of approximately 300 mA. Thus it dissipates
approximately 1.75W of power. In addition, each equivalent video load (150Ω) connected to the outputs should
be budgeted 30 mW of power consumption.
The following calculations show the thermal resistance, θ_JA, required, to ensure safe operation and to prevent
exceeding the maximum junction temperature, given the maximum power dissipation.
P_DMAX = (T_JMAX – T_AMAX)/θ_JA
where
• T_JMAX = Maximum junction temperature = 150°C
• T_AMAX = Maximum ambient temperature = +85°C
• θ_JA = Thermal resistance of the package
(1)
22
Submit Documentation Feedback
Product Folder Links: LMH6586
Copyright © 2008–2013, Texas Instruments Incorporated