THS10082_09 Datasheet, PDF (21/37 Pages) Texas Instruments – 10-BIT, TWO ANALOG INPUT, 8-MSPS, SIMULTANAEOUS SAMPLING

www.ti.com
THS10082
SLAS254B − MAY 2002 − REVISED NOVEMBER 2002
ADC CONTROL REGISTER
The THS10082 contains two 10-bit wide control registers (CR0, CR1) in order to program the device into the desired mode.
The bit definitions of both control registers are shown in Table 7.
Table 7. Bit Definitions of Control Register CR0 and CR1
REG
CR0
CR1
BIT 9
TEST1
RESERVED
BIT 8
TEST0
OFFSET
BIT 7
SCAN
BIN/2’s
BIT 6
DIFF1
R/W
BIT 5
DIFF0
DATA_P
BIT 4
CHSEL1
DATA_T
BIT 3
CHSEL0
TRIG1
BIT 2
PD
TRIG0
BIT 1
MODE
FRST
BIT 0
VREF
RESET
Writing to Control Register 0 and Control Register 1
The 10-bit wide control register 0 and control register 1 can be programmed by addressing the desired control register and
writing the register value to the ADC. The addressing is performed with the upper bits RA0 and RA1. During this write
process, the data bits D0 to D9 contain the desired control register value. Table 8 shows the addressing of each control
register.
Table 8. Control Register Addressing
D0 – D9
Desired register value
Desired register value
Desired register value
Desired register value
RA0
0
1
0
1
RA1
0
0
1
1
Addressed Control Register
Control register 0
Control register 1
Reserved for future
Reserved for future
21