English
Language : 

DS100KR401_13 Datasheet, PDF (18/38 Pages) Texas Instruments – Ultra Low Power, 4 Lane (8-channel, bi-directional) Repeater for Data-rates up to 10.3 Gbps
DS100KR401
SNLS395B – JANUARY 2012 – REVISED MARCH 2012
Table 7. Device Slave Address Bytes
AD[3:0] Settings
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Address Bytes (HEX)
B0
B2
B4
B6
B8
BA
BC
BE
C0
C2
C4
C6
C8
CA
CC
CE
www.ti.com
The SDA, SCL pins are 3.3V tolerant, but are not 5V tolerant. External pull-up resistor is required on the SDA.
The resistor value can be from 1 kΩ to 5 kΩ depending on the voltage, loading and speed. The SCL may also
require an external pull-up resistor and it depends on the Host that drives the bus.
TRANSFER OF DATA VIA THE SMBus
During normal operation the data on SDA must be stable during the time when SCL is High.
There are three unique states for the SMBus:
START: A High-to-Low transition on SDA while SCL is High indicates a message START condition.
STOP: A Low-to-High transition on SDA while SCL is High indicates a message STOP condition.
IDLE: If SCL and SDA are both High for a time exceeding tBUF from the last detected STOP condition or if they
are High for a total exceeding the maximum specification for tHIGH then the bus will transfer to the IDLE state.
SMBus TRANSACTIONS
The device supports WRITE and READ transactions. See Register Description table for register address, type
(Read/Write, Read Only), default value and function information.
18
Submit Documentation Feedback
Product Folder Links: DS100KR401
Copyright © 2012, Texas Instruments Incorporated