English
Language : 

BQ29312_15 Datasheet, PDF (17/39 Pages) Texas Instruments – FOUR CELL LITHIUM-ION
www.ti.com
bq29312
SLUS546E – MARCH 2003 – REVISED MARCH 2005
Register Map
The bq29312 has 9 addressable registers. These registers provide status, control, and configuration information
for the battery protection system.
NAME
STATUS
OUTPUT CTL
STATE CTL
FUNCTION CTL
CELL _SEL
OLV
OLT
SCC
SCD
ADDR
0x00
0x01
0x02
0x03
0x04
0x05
0x06
0x07
0x08
TYPE
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Table 3. Addressable Registers
DESCRIPTION
Status register
Output pin control from system host
State control
Function control
Battery cell select for cell translation and balance bypass and select mode for calibration
Overload threshold voltage
Overload delay time
Short-circuit current threshold voltage and delay for charge
Short-circuit current threshold voltage and delay for discharge
STATUS : Status register
STATUS REGISTER (0x00)
7
6
5
4
3
2
0
0
ZVCLMP
SLEEPDET
WDF
OL
1
SCCHG
0
SCDSG
The STATUS register provides information about the current state of the bq29312. Reading the STATUS register
clears the XALERT pin.
STATUS b0 (SCDSG): This bit indicates a short-circuit in the discharge direction.
0 = Current below the short-circuit threshold in the discharge direction (default).
1 = Current greater than or equal to the short-circuit threshold in the discharge direction.
STATUS b1 (SCCHG): This bit indicates a short-circuit in the charge direction.
0 = Current below the short-circuit threshold in the charge direction (default).
1 = Current greater than or equal to the short-circuit threshold in the charge direction.
STATUS b2 (OL): This bit indicates an overload condition.
0 = Current less than or equal to the overload threshold (default).
1 = Current greater than overload threshold.
STATUS b3 (WDF): This bit indicates a watchdog fault condition has occurred.
0 = 32 kHz oscillation is normal (default).
1 = 32 kHz oscillation stopped or not started and the watchdog has timed out.
STATUS b4 (SLEEPDET): This bit indicates the bq29312 is SLEEP mode.
0 = bq29312 is not SLEEP mode (default).
1 = bq29312 is SLEEP mode.
STATUS b5 (ZVCLMP): This bit indicates ZVCHG output is clamped.
0 = ZVCHG pin is not clamped (default).
1 = ZVCHG pin is clamped.
17