TIBPSG507AC Datasheet, PDF (15/19 Pages) Texas Instruments – 13 × 80 × 8 PROGRAMMABLE SEQUENCE GENERATOR

TIBPSG507AC
13 × 80 × 8 PROGRAMMABLE SEQUENCE GENERATOR
SRPS002D – D3029, MAY 1987 – REVISED NOVEMBER 1995
PARAMETER MEASUREMENT INFORMATION
5V
From Output
Under Test
CL
(see Note A)
S1
R1
Test
Point
R2
LOAD CIRCUIT FOR
3-STATE OUTPUTS
Timing
Input
tsu
Data
Input
1.5 V
th
1.5 V
1.5 V
VOLTAGE WAVEFORMS
SETUP AND HOLD TIMES
3.5 V
0.3 V
3.5 V
0.3 V
Input
tpd
In-Phase
Output
tpd
Out-of-Phase
Output
(see Note D)
1.5 V
1.5 V
1.5 V
1.5 V
3.5 V
0.3 V
tpd
VOH
1.5 V
VOL
tpd
VOH
1.5 V
VOL
VOLTAGE WAVEFORMS
PROPAGATION DELAY TIMES
High-Level
Pulse
1.5 V 1.5 V
tw
3.5 V
0.3 V
Low-Level
Pulse
1.5 V 1.5 V
3.5 V
0.3 V
VOLTAGE WAVEFORMS
PULSE DURATIONS
Output
Control
(low–level
enabling)
ten
Waveform 1
S1 Closed
(see Note B)
ten
Waveform 2
S1 Open
(see Note B)
1.5 V
tdis
1.5 V
tdis
1.5 V
1.5 V
3.5 V
0.3 V
≈ 3.3 V
VOL +0.5 V
VOL
VOH
VOH –0.5 V
≈0V
VOLTAGE WAVEFORMS
ENABLE AND DISABLE TIMES, 3-STATE OUTPUTS
NOTES: A. CL includes probe and jig capacitance and is 50 pF for tpd and ten, 5 pF for tdis.
B. Waveform 1 is for an output with internal conditions such that the output is low except when disabled by the output control. Waveform 2
is for an output with internal conditions such that the output is high except when disabled by the output control.
C. All input pulses have the following characteristics: PRR ≤ 1 MHz, tr = tf ≤ 2 ns, duty cycle = 50%.
D. When measuring propagation delay times of 3-state outputs, switch S1 is closed.
E. Equivalent loads may be used for testing.
Figure 6. Load Circuit and Voltage Waveforms
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
15