DS90UB903QSQ Datasheet, PDF (36/45 Pages) Texas Instruments – DS90UB903Q/DS90UB904Q 10 - 43MHz 18 Bit Color FPD-Link III Serializer and Deserializer

DS90UB903Q, DS90UB904Q
SNLS332E – JUNE 2010 – REVISED APRIL 2013
www.ti.com
Some devices provide separate power for different portions of the circuit. This is done to isolate switching noise
effects between different sections of the circuit. Separate planes on the PCB are typically not required. Pin
Description tables typically provide guidance on which circuit blocks are connected to which power pin pairs. In
some cases, an external filter many be used to provide clean power to sensitive circuits such as PLLs.
Use at least a four layer board with a power and ground plane. Locate LVCMOS signals away from the
differential lines to prevent coupling from the LVCMOS lines to the differential lines. Closely-coupled differential
lines of 100 Ohms are typically recommended for differential interconnect. The closely coupled lines help to
ensure that coupled noise will appear as common-mode and thus is rejected by the receivers. The tightly coupled
lines will also radiate less.
Information on the WQFN style package is provided in Application Note: AN-1187 “Leadless Leadframe Package
(LLP) Application Report” (literature number SNOA401).
INTERCONNECT GUIDELINES
See AN-1108 (SNLA008) and AN-905 (SNLA035) for full details.
• Use 100Ω coupled differential pairs
• Use the S/2S/3S rule in spacings
– S = space between the pair
– 2S = space between pairs
– 3S = space to LVCMOS signal
• Minimize the number of Vias
• Use differential connectors when operating above 500Mbps line speed
• Maintain balance of the traces
• Minimize skew within the pair
Additional general guidance can be found in the LVDS Owner’s Manual - available in PDF format from the Texas
Instruments web site at: www.ti.com/lvds
36
Submit Documentation Feedback
Copyright © 2010–2013, Texas Instruments Incorporated
Product Folder Links: DS90UB903Q DS90UB904Q