English
Language : 

BQ24292I Datasheet, PDF (23/42 Pages) Texas Instruments – I2C Controlled 4.5A Single Cell USB/Adapter Charger With Narrow VDC Power Path Management and USB OTG
www.ti.com
Voltage
9V
3.6V
3.4V
3.2V
3.18V
VBUS
SYS
BAT
bq24292i
SLUSBI4 – APRIL 2013
Current
4A
3.2A
2.8A
ISYS
ICHG
1.2A
IIN
1.0A
0.5A
-0.6A
DPM
DPM
Supplement
Figure 26. DPM Response
Supplement Mode
When the system voltage falls below the battery voltage, the BATFET turns on and the BATFET gate is
regulated the gate drive of BATFET so that the minimum BATFET VDS stays at 30mV when the current is low.
This prevents oscillation from entering and exiting the supplement mode. As the discharge current increases, the
BATFET gate is regulated with a higher voltage to reduce RDSON until the BATFET is in full conduction. At this
point onwards, the BATFET VDS linearly increases with discharge current. Figure 27 shows the V-I curve of the
BATFET gate regulation operation. BATFET turns off to exit supplement mode when the battery is below battery
depletion threshold.
4.5
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
0
5 10 15 20 25 30 35 40 45 50 55
V(BAT-SYS) (mV)
Figure 27. BATFET V-I Curve
Battery Charging Management
The device charges 1-cell Li-Ion battery with up to 4.5A charge current for high capacity tablet battery. The 12mΩ
BATFET improves charging efficiency and minimizes the voltage drop during discharging.
Autonomous Charging Cycle
With battery charging enabled at POR (REG01[5:4]=01), the device can complete a charging cycle without host
involvement. The device default charging parameters are listed in .
Copyright © 2013, Texas Instruments Incorporated
Product Folder Links :bq24292i
Submit Documentation Feedback
23