BQ4010 Datasheet, PDF (2/14 Pages) Texas Instruments – 8Kx8 Nonvolatile SRAM

bq4010/bq4010Y
Functional Description
When power is valid, the bq4010 operates as a standard
CMOS SRAM. During power-down and power-up cycles,
the bq4010 acts as a nonvolatile memory, automatically
protecting and preserving the memory contents.
Power-down/power-up control circuitry constantly
monitors the VCC supply for a power-fail-detect threshold
VPFD. The bq4010 monitors for VPFD = 4.62V typical for
use in systems with 5% supply tolerance. The bq4010Y
monitors for VPFD = 4.37V typical for use in systems with
10% supply tolerance.
When VCC falls below the VPFD threshold, the SRAM
automatically write-protects the data. All outputs
become high impedance, and all inputs are treated as
“don’t care.” If a valid access is in process at the time of
power-fail detection, the memory cycle continues to com-
pletion. If the memory cycle fails to terminate within
time tWPT, write-protection takes place.
As VCC falls past VPFD and approaches 3V, the control
circuitry switches to the internal lithium backup supply,
which provides data retention until valid VCC is applied.
When VCC returns to a level above the internal backup
cell voltage, the supply is switched back to VCC. After
VCC ramps above the VPFD threshold, write-protection
continues for a time tCER (120ms maximum) to allow for
processor stabilization. Normal memory operation may
resume after this time.
The internal coin cell used by the bq4010 has an
extremely long shelf life and provides data retention for
more than 10 years in the absence of system power.
As shipped from Benchmarq, the integral lithium cell is
electrically isolated from the memory. (Self-discharge in
this condition is approximately 0.5% per year.) Following
the first application of VCC, this isolation is broken, and
the lithium backup cell provides data retention on
subsequent power-downs.
Truth Table
Mode
Not selected
Output disable
Read
Write
CE
WE
OE
I/O Operation
Power
H
X
X
High Z
Standby
L
H
H
High Z
Active
L
H
L
DOUT
Active
L
L
X
DIN
Active
Absolute Maximum Ratings
Symbol
Parameter
Value
Unit
Conditions
VCC
VT
TOPR
DC voltage applied on VCC relative to VSS
DC voltage applied on any pin excluding VCC
relative to VSS
Operating temperature
-0.3 to 7.0
-0.3 to 7.0
0 to +70
-40 to +85
V
V
VT ≤ VCC + 0.3
°C
Commercial
°C
Industrial “N”
TSTG
Storage temperature
-40 to +70
-40 to +85
°C
Commercial
°C
Industrial “N”
TBIAS
Temperature under bias
-10 to +70
-40 to +85
°C
Commercial
°C
Industrial “N”
TSOLDER Soldering temperature
+260
°C
For 10 seconds
Note:
Permanent device damage may occur if Absolute Maximum Ratings are exceeded. Functional operation
should be limited to the Recommended DC Operating Conditions detailed in this data sheet. Exposure to con-
ditions beyond the operational limits for extended periods of time may affect device reliability.
Sept. 1996 D
6-2