TMS320C6672_15 Datasheet, PDF (130/238 Pages) Texas Instruments – Multicore Fixed and Floating-Point Digital Signal Processor

TMS320C6672
Multicore Fixed and Floating-Point Digital Signal Processor
SPRS708E—March 2014
Table 7-8
PSC Register Memory Map (Part 3 of 3)
Offset
0xA48
0xA4C
0xA50
0xA54
0xA58
0xA5C - 0xFFC
End of Table 7-8
Register
MDCTL18
MDCTL19
MDCTL20
MDCTL21
MDCTL22
Reserved
Description
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
1 VCNTLID register is available for debug purposes only.
7.5 Reset Controller
The reset controller detects the different type of resets supported on the TMS320C6672 device and manages the
distribution of those resets throughout the device.
The device has several types of resets:
• Power-on reset
• Hard reset
• Soft reset
• CPU local reset
Table 7-9 explains further the types of reset, the reset initiator, and the effects of each reset on the device. For more
information on the effects of each reset on the PLL controllers and their clocks, see Section ‘‘Reset Electrical Data /
Timing’’ on page 135
Table 7-9
Reset Types
Reset Type
Initiator
POR (Power On Reset) POR pin active low
RESETFULL pin active low
Hard Reset
Soft Reset
C66x CorePac
local reset
RESET pin active low
Emulation
PLLCTL register (RSCTRL)
Watchdog timers
RESET pin active low
PLLCTL register (RSCTRL)
Watchdog timers
Software (through
LPSC MMR)
Watchdog timers
LRESET pin
End of Table 7-9
Effect on Device When Reset Occurs
RESETSTAT Pin Status
Total reset of the chip. Everything on the device is reset to its default Toggles RESETSTAT pin
state in response to this. Activates the POR signal on chip, which is used
to reset test/emu logic. Boot configurations are latched. ROM boot
process is initiated.
Resets everything except for test/emu logic and reset isolation
modules. Emulator and reset Isolation modules stay alive during this
reset. This reset is also different from POR in that the PLLCTL assumes
power and clocks are stable when device reset is asserted. Boot
configurations are not latched. ROM boot process is initiated.
Toggles RESETSTAT pin
Software can program these initiators to be hard or soft. Hard reset is
the default, but can be programmed to be soft reset. Soft reset will
behave like hard reset except that EMIF16 MMRs, DDR3 EMIF MMRs, the
sticky bits in PCIe MMRs, and external memory contents are retained.
Boot configurations are not latched. ROM boot process is initiated.
Toggles RESETSTAT pin
MMR bit in LPSC controls C66x CorePac local reset. Used by watchdog
timers (in the event of a timeout) to reset C66x CorePac. Can also be
initiated by LRESET device pin. C66x CorePac memory system and slave
DMA port are still alive when C66x CorePac is in local reset. Provides a
local reset of the C66x CorePac, without destroying clock alignment or
memory contents. Does not initiate ROM boot process.
Does not toggle
RESETSTAT pin
130 Peripheral Information and Electrical Specifications
Copyright 2014 Texas Instruments Incorporated
Submit Documentation Feedback