71M6521BE Datasheet, PDF (43/97 Pages) Teridian Semiconductor Corporation – Energy Meter IC

71M6521BE
Energy Meter IC
DATA SHEET
JANUARY 2008
Control
Bit
7
6
5
4
3-0
Name
WFR
BUSY
HiZ
RD
CNT[3:0]
Read/Write Description
Wait for Ready. If this bit is set, the trailing edge of BUSY will be delayed
until a rising edge is seen on the data line. This bit can be used during the
W
last byte of a Write command to cause the INT5 interrupt to occur when the
EEPROM has finished its internal write sequence. This bit is ignored if
HiZ=0.
R
Asserted while serial data bus is busy. When the BUSY bit falls, an INT5
interrupt occurs.
W
Indicates that the SD signal is to be floated to high impedance immediately
after the last SCK rising edge.
W
Indicates that EEDATA is to be filled with data from EEPROM.
Specifies the number of clocks to be issued. Allowed values are 0 through
8. If RD=1, CNT bits of data will be read MSB first, and right justified into
W
the low order bits of EEDATA. If RD=0, CNT bits will be sent MSB first to
EEPROM, shifted out of EEDATA’s MSB. If CNT is zero, SDATA will
simply obey the HiZ bit.
Table 57: EECTRL bits for 3-wire interface
EECTRL Byte Written
Write -- No HiZ
SCLK (output)
CNT Cycles (6 shown)
INT5
SDATA (output)
D7
D6
D5
D4
D3
D2
SDATA output Z
(LoZ)
BUSY (bit)
Figure 9: 3-Wire Interface. Write Command, HiZ=0.
EECTRL Byte Written
Write -- With HiZ
SCLK (output)
CNT Cycles (6 shown)
SDATA (output)
D7
D6
D5
D4
D3
D2
SDATA output Z
(LoZ)
BUSY (bit)
INT5
(HiZ)
Figure 10: 3-Wire Interface. Write Command, HiZ=1
V1.0
© 2005-2008 TERIDIAN Semiconductor Corporation
Page: 43 of 97