71M6521BE Datasheet, PDF (12/97 Pages) Teridian Semiconductor Corporation – Energy Meter IC

71M6521BE
Energy Meter IC
DATA SHEET
JANUARY 2008
Battery Monitor
The battery voltage is measured by the ADC during alternative multiplexer frames if the BME (Battery Measure Enable) bit in
the I/O RAM is set. While BME is set, an on-chip 45kΩ load resistor is applied to the battery, and a scaled fraction of the
battery voltage is applied to the ADC input. After each alternative MUX frame, the result of the ADC conversion is available at
CE DRAM address 07. BME is ignored and assumed zero when system power is not available (V1 < VBIAS). See the Battery
Monitor section of the Electrical Specifications for details regarding the ADC LSB size and the conversion accuracy.
Functional Description
The AFE functions as a data acquisition system, controlled by the MPU. The main signals (IA, VA, IB, VB) are sampled and
the ADC counts obtained are stored in CE DRAM where they can be accessed by the CE and, if necessary, by the MPU.
Alternate multiplexer cycles are initiated less frequently by the MPU to gather access to the slow temperature and battery
signals.
VREF
IA
VA
IB
MUX
VB
VBAT
VBIAS
TEMP
MUX
MUX
CTRL
EQU
MUX_ALT
CHOP_E
MUX_DIV
VREF
VREF_CAL
VREF_DIS
CROSS
CK32
VBIAS
ΔΣ ADC
CONVERTER
V3P3A
-
+
ADC_E
VREF
FIR_DONE
FIR_START
4.9MHz
FIR
FIR_LEN
Figure 3: AFE Block Diagram
Digital Computation Engine (CE)
The CE, a dedicated 32-bit signal processor, performs the precision computations necessary to accurately measure energy.
The CE calculations and processes include:
• Multiplication of each current sample with its associated voltage sample to obtain the energy per sample (when
multiplied with the constant sample time).
• Frequency-insensitive delay cancellation on all channels (to compensate for the delay between samples caused by
the multiplexing scheme).
• Pulse generation.
• Monitoring of the input signal frequency (for frequency and phase information).
• Monitoring of the input signal amplitude (for sag detection).
• Scaling of the processed samples based on calibration coefficients.
The CE program resides in flash memory. Common access to flash memory by CE and MPU is controlled by a memory share
circuit. Each CE instruction word is two bytes long. Allocated flash space for the CE program cannot exceed 1024 words
(2KB). The CE program counter begins a pass through the CE code each time multiplexer state 0 begins. The code pass ends
when a HALT instruction is executed. For proper operation, the code pass must be completed before the multiplexer cycle
ends (see System Timing Summary in the Functional Description Section).
Page: 12 of 97
© 2005-2008 TERIDIAN Semiconductor Corporation
V1.0