STE2007 Datasheet, PDF (49/62 Pages) STMicroelectronics – 96 x 68 Single Chip LCD Controller/Driver

STE2007
8 Commands
8.12.3 Electronic volume
This command sets a value of electronic volume EV for the VLCD voltage regulator, to adjust
the contrast of LCD panel display (End User).
Table 34. Electronic volume
(D/C) D7 D6 D5 D4 D3 D2 D1 D0
0
1
0
0
Electronic Volume Value
Setting
Command Identifier + Data Field
Table 35. EV
(D/C) D7 D6 D5 D4 D3 D2 D1 D0 Hex
EV Value
VLCD voltage
0
1
0
0
0
0
0
0
0 80
0 Step
low
0
0
0
0
0
1 81
1 Step
0
0
0
0
1
0 82
2 Step
:
:
:
:
:
0
1
0
0
0
0 90 16 Step (Default)
:
:
:
:
:
0
1
1
1
1
0 9E
30 Step
0
1
1
1
1
1 9F
31 Step
high
8.13 Power saver mode
If the display all points ON command is executed when the display is in display OFF mode,
power saver mode is entered. This mode stops every operation of the LCD display system.
Figure 37. Power saver mode
Power saver (Display OFF & Display all points ON
Power saver mode
Powersaver OFF (Display all points OFF)
Power saver mode canceled
Command
Effect
The internal states in power saver mode are as follows:
– The oscillation circuit is stopped
– The LCD power supply circuit is stopped
– The LCD driver circuit is stopped and segment/common driver outputs to the Vss
level
49/62