SLWSTK6000A Datasheet, PDF (28/80 Pages) Silicon Laboratories – ConfidentialMighty Gecko Wireless SoC EFR32MG1X232

EFR32MG1X232 Data Sheet
Electrical Characteristics
Parameter
Symbol
Test Condition
Min
Typ
Max
Unit
Confidential ^{Blocking,0.1%BER,Desired BLOCKOOB}
Interferer frequency 30 MHz ≤ f ≤
-
-30
-
dBm
is reference signal at 3 dB
2000 MHz
above reference sensitivity
level. Interferer is CW in
OOB range.
Interferer frequency 2003 MHz ≤ f
-
-35
-
dBm
≤ 2399 MHz
Interferer frequency 2484 MHz ≤ f
-
-35
-
dBm
≤ 2997 MHz
Interferer frequency 3 GHz ≤ f ≤
-
-30
-
dBm
12.75 GHz
Intermodulation performance IM
per Core_4.1, Vol 6 Section
4.4 (n = 3 alternative), 0.1%
BER.
Desired is reference signal at 6dB
-
-33
-
dBm
above reference sensitivity level.
Interferer 1 is CW at level IM_BLE.
Interferer 2 is reference signal at
IM_BLE.
Upper limit of input power RSSI_MAX
range over which RSSI reso-
lution is maintained
TBD
-
-
dBm
Lower limit of input power RSSI_MIN
range over which RSSI reso-
lution is maintained
-
-
TBD
dBm
RSSI resolution
RSSI_RES
Over RSSI_MIN to RSSI_MAX
-
-
TBD
dB
Note:
1. Reference signal is defined in Core_4.2, Vol 6, Section 4.6. 2GFSK, Modulation index = 0.5, BT = 0.5, Bit rate = 1 Mbps, desired
data = PRBS9; interferer data = PRBS15; frequency accuracy better than 1 ppm
2. Target for planned revision. Current silicon performance is -92.1 dBm
3. Allowable exceptions for spurious response RF channels, as specified in Core_4.2, Vol 6, Section 4.2 "Interference Perform-
ance". Where there is conflict of specifications regarding interference at image frequencies, the less stringent specification ap-
plies.
4. Selectivity to image frequency -1 MHz corresponds to C/I₁₊ N+1 adjacent hannel selectivity
silabs.com | Smart. Connected. Energy-friendly.
Preliminary Rev. 0.71 | 27